User manual THETFORD C-250

[. . . ] Next add approximately 2 litres of water - enough to ensure that the bottom of the waste-holding tank is covered. For more information on Thetford toilet fluids, see last page of this manual. Screw the cap back onto the emptying spout and turn back to its original position. Never add toilet fluid directly via the blade or the toilet bowl as this could damage the lip seal of the waste-holding tank. [. . . ] Waste Pump-Out system: When activating the control panel this feature automatically lights up. When the waste-holding tank level indicator illuminates, press the Waste Pump-Out button to pump out the waste from the holding tank into the vehicle's waste tank. The button will flash while the waste is being pumped and will stop automatically (after approximately 2 minutes) when all waste has been transferred. If the vehicle's waste tank is full, the Waste Pump-Out light will flash rapidly and no pump-out will be possible until the central tank is emptied. (Check the level of the vehicle's waste tank regularly). After the waste-holding tank has been emptied, there will be approximately 1. Before activating the Waste Pump-Out system, make sure that the central waste-holding tank has still enough capacity (approximately 18L) Important!For a proper breakdown of the waste and functioning of the Waste Pump-Out system it is important to use Thetford additives and Aqua Soft toiletpaper. It is vital that the correct amount of Thetford toilet fluid is added to ensure the proper breakdown of the waste in the waste-holding tank. Only use the system when the waste-holding tank is filled. Using the system too often on an empty waste-holding tank can cause damage to the pump, which could cause the system to fail. The waste-holding tank requires emptying when the red light (LED) on the toilet control display lights up. The red light lights up, when the waste-holding tank only has capacity for approximately 2 more litres, which is no more than two to three further uses. Open the access door located outside the vehicle, pull the safety catch on the waste-holding tank upwards and remove the waste-holding tank by pulling the tank towards you. Release the handle from the snaps, pull the handle up and wheel the waste-holding tank to an authorized waste disposal point. Push the handle back into its locked position. Turn the emptying spout upwards and remove the cap from the spout. Hold the waste-holding tank in such a way that during emptying you can operate the vent plunger with your thumb. To empty the tank without splashing, depress the vent plunger while emptying the tank. After emptying, rinse the tank and blade thoroughly with water. To clean Thetford toilets, we advise using water and Thetford Bathroom Cleaner & Thetford Toilet Bowl Cleaner. Never use bleach, vinegar or other powerful household cleaners that contain these substances. [. . . ] The information available includes frequently asked questions, trouble shooting, instructions for repair, tips, and a list of Thetford Dealers and Service Centres near you. If you still have questions or remarks, please contact the Customer Service Department in your country (see the addresses on the back of this manual). Thetford is not liable for loss and/or damage caused directly or indirectly by use of the toilet. Den röda lampan tänds när avfallstanken bara har kapacitet för ungefär 2 liter till, vilket inte är mer än två till tre ytterligare användningar. [. . . ]