User manual THOMSON 28WF25

[. . . ] Insert 2 new batteries of type "CR2025" or "AAA/LR03" (depending on your model). In the enclosed code list, find your TV brand or manufacturer (e. Beside the manufacturer's name, you will find one or more 3-digit codes. [. . . ] Press and hold the key until your TV switches off. Please note that this process might take up to 15 minutes. During the automatic scanning you can remove your finger or change hands provided it is replaced within 8 seconds. If left off of the key for more than 8 seconds then the remote will revert back to its normal mode. If your TV switches into Stand-By mode during the automatic process then immediately remove your finger from the key and then press the TV key until the LED flashes twice, this will then store the code that the remote control has found. In some cases during the automatic scanning search the remote control might find several codes that appear to operate your TV etc, however, if some of the buttons fail to work properly then it’s possible the remote has found a partially compatible code. In such cases you will need to restart the automatic scanning process (steps B. Please note that once the automatic process is restarted, the remote continues from the last stored code and not at the beginning of code database. €¢ To complete a code scan for the VCR, DVD, CD or TAPE, follow the procedure above but use the key and not the key • To complete a code scan for the TUNER, follow the procedure above but use the key 2 Easy programming for the control of your VIDEO RECORDER To programme the remote control to operate your VIDEO RECORDER, proceed as described above for the television set. Complete steps 1 to 10 using the VCR key on your remote control. Please ensure that you refer to the codes listed under the VIDEO RECORDER section and not the TV section. Easy programming for the control of your SATELLITE RECEIVER To programme the remote control to operate your SATELLITE RECEIVER or CABLE BOX, proceed as described for the television set. Complete steps 1 to 10 using the SAT key on your remote control. Please ensure that you refer to the codes listed under the SATELLITE section and not the TV section. Easy programming for the control of your DVD PLAYER To programme the remote control to operate your DVD PLAYER, proceed as described for the television set. Complete steps 1 to 10 using the DVD key on your remote control. Please ensure that you refer to the codes listed under the DVD section and not the TV section. 2 3 GB USER MANUAL GB USER MANUAL Code scan for VCR, SAT, DVD, CD, TAPE, TUNER and AMP To complete a code scan for VCR, SAT, DVD, CD, TAPE, TUNER or AMP, proceed as described for a TV code scan. [. . . ] Complete steps A to F, pressing the VCR , SAT , DVD , CD , TAPE , TUNER or AMP key respectively. Write down the code number as indicated by the LED. TV VCR SAT/CABLE DVD/AUX CD TAPE TUNER AMPLIFIER Programming for AUX devices Depending on the model, you can use your universal remote control to operate a second TV set, video recorder, satellite receiver/cable box, CD player, tape recorder, tuner or amplifier. [. . . ]