User manual THOMSON 30LCDB03B

[. . . ] To ensure your safety and prolong the service life of your LCD TV product, please read the following precautions carefully before using the product. 1. Read instructions--All operating instructions must be read and understood before the product is operated. 2. Retain instructions--These safety and operating instructions must be kept in a safe place for future reference. 3. Observe warnings--All warnings on the product and in the instructions must be observed closely. [. . . ] name option and press the button to place the cursor on the first character. Using the / buttons, select a character from the list, which includes letters from the alphabet, numbers between 0 and 9, the characters +, . Go on to the next character or back to the previous character using the / buttons and start the procedure again. Names can have a maximum of six characters. Note : You may subsequently return to ORGANISER menu by selecting the Organiser line in the INSTALLATION menu. 12 Manual channel set-up Follow the procedure given on this page if you find that some channels have not been stored during the initial setup. This can happen if you are setting up cable network channels. Setting up channels manually requires every setting for a particular channel to be entered, one at a time. Display the OVERVIEW menu by pressing the MANUAL INSTALLATION MENU button. Return Standard Frequency Programme name Fine-tuning Store on prog. Select the Installation option and press OK to confirm. Select the relevant country and press OK. Or if you press EXIT button, you will also stop the auto update fuction. OPERATION General operation Switching the TV set on and off To switch the TV set on, press the button located on the right side of the set. When the set is on, the indicator on the front is green. Standby mode Press the button on the screen right side of TV or on the remote control. The TV set remains powered up, but with low energy consumption. When the TV set is in standby mode, the indicator on the front is red. Quitting standby mode or any numeric button on the remote control, - Press the - press the PR+/PR- buttons to switch on the television at the last channel or AV programme you were watching, - press the AV button to switch the television on at the last AV programme you were watching. Volume Volume control: use the VOL + / - buttons on the right side of the TV set or press the same buttons on the remote control to increase or decrease the volume. Press this button again or the VOL+ button to Displaying status information In TV mode, press the yellow button (INFO) on the remote control to display the number and name of the channel you are watching, the type of sound, the zoom or format type, sound mute status and the sleep timer status (if active). TV lock message is displayed if the function is activated under the PREFERENCES menu. When you switch on the television or change channels, the number and name of the channel are displayed if you entered its name under the ORGANISER menu. In PC and PIC(see page 21) modes, press the yellow button (INFO) on the remote control to display the Resolution , Vertical and Horizontal frequency. Accessing channels Using the numeric buttons: - for channels 1 to 9, press the corresponding button. [. . . ] Check for incorrect battery orientation. Check for dead batteries Check for distance and angle from the display. Check whether remote control is properly being pointed at the display's receiver. Check for any obstacle between the remote control and the display. [. . . ]