User manual THOMSON 32VT68NV

[. . . ] To ensure your safety and prolong the service life of your LCD TV product, please read the following precautions carefully before using the product. 1. Read instructions--All operating instructions must be read and understood before the product is operated. 2. Retain instructions--These safety and operating instructions must be kept in a safe place for future reference. 3. Observe warnings--All warnings on the product and in the instructions must be observed closely. [. . . ] Display the OVERVIEW menu by pressing the @ MANUAL INSTALLATION MENU button. Return Standard Frequency Programme name Fine-tuning Store on programme Decoder Teletext char. 150. 75MHz BBC2 ------|---------02 o 1. . . Select the Installation option and press OK to confirm. Select the relevant country and press OK. Select the Manual Installation option from the INSTALLATION menu and press OK to confirm. 1. Select the Standard option and then the relevant standard for your country using the / ÿ buttons. Note: the following standards are available to choose from: UK for the UK and Ireland, FR for France and Luxembourg, DK for Eastern Europe , the Middle East and Asia, EURO for Western Europe, Australia and New Zealand. Use the or ÿ button to start the search in descending or ascending order. When a channel is found, pictures appear. Note : If the channel name is found, it is displayed next to Programme name option. Quitting standby mode - Press the or any numeric button on the remote control, - press the PR+/PR- buttons to switch on the television at the last channel or AV programme you were watching, - press the AV button to switch the television on at the last AV programme you were watching. Volume Volume control: use the VOL + / - buttons on the right side of the TV set or press the same buttons on the remote control to increase or decrease the volume. Press this button again or the VOL+ button to Displaying status information In TV mode, press the yellow button (INFO) on the remote control to display the number and name of the channel you are watching, the type of sound, the zoom or format type, sound mute status and the sleep timer status (if active). TV lock message is displayed if the function is activated under the PREFERENCES menu. When you switch on the television or change channels, the number and name of the channel are displayed if you entered its name under the ORGANISER menu. In PC and PIC(see page 21) modes, press the yellow button (INFO) on the remote control to display the Resolution , Vertical and Horizontal frequency. Accessing channels Using the numeric buttons: - for channels 1 to 9, press the corresponding button. - for channels 10 to 99, press the 0 button to display "--", then enter the two digits. Using the PR+/PR- buttons: scroll through the channels. AV programmes are not included in the cycle unless you use the buttons on the right side of the TV set. Accessing AV programmes Press the AV button to display the last selected audio-visual programmes and scan through the other audio-visual programmes. AV selections loop (26"): AV1, AV1 RGB, AV2/AV2-S, YCrCb/YPrPb, VGA. AV selections loop (32"): AV1/AV1 RGB, AV1 RGB, AV2/AV2-S, AV3/AV3-S, YCrCb/YPrPb, VGA. Nota: If you select VGA when an YPrPb signal is available on D-sub socket, the displayed picture will be green. [. . . ] Check for dead batteries Check for distance and angle from the display. Check whether remote control is properly being pointed at the display's receiver. Check for any obstacle between the remote control and the display. Check that the remote sensor window is not under strong fluorescent lighting. [. . . ]