User manual THOMSON 42WM03STW

[. . . ] Important safety instructions WARNINGS & PRECAUTIONS Ensure that your domestic mains supply voltage matches the voltage indicated on the identification label located at the back of the set. The monitor components are sensitive to heat. The maximum ambient temperature should not exceed 35o Celsius. Do not cover the vents at the back of the monitor. [. . . ] Press exit to close the menu. EN 11 MANUAL INSTALLATION Return Standard Frequency Name Fine-tuning Store on PR: Decoder Text EURO 150. 75 MHz BBC2 02 1 Note: The INSTALLATION menu is only available in video mode (TV channels or AV programmes). 42WM03STW-0707-en. p65 11 2003/9/5, PM 12:53 General operation Switching the set on and off To switch the TV set on, put the main power switch located at the rear on the ON position, then press the power button located on the front panel. When the set is on, the indicator on the front is green. Standby mode: press the power button on the front panel. When the TV set is in standby mode, the indicator on the front is orange. EN 12 Volume Volume control: use the buttons on the front panel or the remote control to increase and decrease the volume. Sound mute: press the button on the remote control to temporarily mute the sound. To restore it, press the Displaying status information In TV mode, press the yellow info button on the remote control to display the number and name of the channel you are watching, the zoom format, the type of sound, and the remaining time if the sleep timer is on. The number and name of the channel are displayed whenever you turn on the TV set or change channels. Accessing TV channels Using the numeric buttons: for channels 1 to 9, press the corresponding button. For two-digit channels, first press the 0/-- button, then the channel number (e. g. Using the pr+/pr- buttons: scan through the programmes. AV programmes are not accessible. Accessing AV programmes Press the av button to display the last selected AV programme and scan through the other AV programmes. 42WM03STW-0707-en. p65 12 2003/9/5, PM 12:53 Adjusting the picture Display the OVERVIEW menu using the menu button. The contents of this menu depends on the signal. Picture menu in TV mode In TV mode: Adjust the Brightness, Contrast, Colour and Sharpness settings as required. The Tint option is only available when a NTSC signal is detected. It is used for adjusting the picture's tint. To adjust the colour temperature, select the Tone option and select a setting using the and buttons. Check the box for the Auto format option so that the appropriate format is automatically applied to the picture. Note: if you are watching an AV programme through AV2 or Component Y/CR/CB, this function is not available. Use the Noise reduction function to improve the quality of the picture in the case of poor reception. Use the and buttons to select one of the options. EN 13 Picture menu in PC mode PICTURE Return Brightness Contrast Tone V-Size V-Position H-Size H-Position Phase In PC mode: Adjust the Brightness and Contrast settings as required. To adjust the colour temperature, select the Tone option and select a setting using the and buttons. Use the V-Size option to change the vertical size of the picture. Using the and buttons, move the cursor to the right to enlarge the picture, or to the left to reduce it. Use the V-position to move the picture vertically. [. . . ] If under RGB mode, the H-Size and V-Size settings are incorrectly set. The signal cable is not connected properly. The signal cable is not connected properly. The sound is muted. The remote control buttons do not work. 1. [. . . ]