User manual THOMSON BOT610MXD

[. . . ] Dear Customer, You have just acquired a THOMSON oven and we would like to thank you. We have invested all our dedication and know-how in this appliance so that it would best meet your needs. With innovation and performance, we designed it to be always easy to use. In the THOMSON product range, you will also find a wide choice microwaves, cooking hobs, ventilation hoods, that you can coordinate with your new THOMSON oven. [. . . ] -- We thank you for your help in protecting the environment. This appliance complies with the following European directives: - Low Voltage Directive 2006/95/CE for affixing the CE mark. The above diagrams show the dimensions of a cabinet that will be able to hold your oven. The oven can be installed under a work top or in a column of cabinetry (open* or closed) having the appropriate dimensions for built-in installation (see adjacent diagram). Your oven has optimised air circulation that allows it to achieve remarkable cooking and cleaning results if the following guidelines are followed: · Centre the oven in the cabinet so as to guarantee a minimum distance of 5 mm between the appliance and the cabinet beside it. For greater stability, attach the oven in the cabinet with two screws through the holes provided for this purpose on either side of the front inner panel (fig. (*) if the cabinet is open, its opening must be 70 mm (maximum). To be certain that you have properly installed your appliance, do not hesitate to call on a household appliance specialist. During fitting and maintenance operations, the appliance must be unplugged from the electrical grid. The electrical connections are made before the appliance is installed in its housing. Ensure that: - the electrical installation has sufficient voltage, - the electrical wires are in good condition, - the diameter of the wires complies with the installation requirements. Your oven must be connected with a (standard) power cable with 3 conductors of 1. 5mm2 (1 live + 1 neutral + earth) which must be connected to a 220-240V~ single-phase 7 grid by means of a 1 live + 1 neutral + earth CEI 60083 standard power socket or via an all-poles cut-off device in compliance with the installation rules. The safety wire (green-yellow) is connected to the appliance's terminal and must be connected to the earth terminal of the electrical set-up. If the connection is to an electric wall socket, it must remain accessible after installation. The fuse in your set-up must be 16 amperes. We cannot be held responsible for any accident resulting from inexistent, defective or incorrect earthing. If the electrical installation in your residence requires any changes in order to hook up your appliance, contact a professional electrician. If the oven malfunctions in any way, unplug the appliance or remove the fuse corresponding to the sector where the oven is hooked up. -- The power cable (H05 RR-F, H05 RN-F or H05 VV-F) must be of sufficient length to be connected to the build-in oven while it sits on the floor in front of the cabinet. To do this the appliance must be disconnected from the electrical network: -- Open the inspection flap located at the lower right of the back cover by unscrewing the two screws, then pivot the inspection flap. -- Strip 12 mm along each wire of the new power cable. [. . . ] - After cleaning, reposition the four rubber pads, taking care to follow the indications on the glass: * top left: L * top right: R Place your inner glass assembly in the door so that L and R are located on the hinge side. - If your oven is equipped with a single inner sheet of glass, it must be located as close as possible to the clipped glass. - Clip in your last glass sheet by placing the indication "PYROLYSIS" so that it faces you (fig. Do not use abrasive cleaning products or hard metallic scrapers for cleaning the oven's glass door, as they could scuff the surface and cause the glass to shatter. [. . . ]