User manual THOMSON CS500

[. . . ] u s e r m a n VOLUME DEMO TUNE/PRESET ON/ECO SOURCE u DISC SKIP DISC OPEN/CLOSE CD-R / RW COMPATIBLE a 5 DISC CHANGER l THOMSON 46, quai Alphonse Le Gallo 92648 Boulogne Cedex FRANCE 55806290 www. thomson. net CS500 Safety Information EN Thomson Information CAUTION!This system must be opened only by qualified technicians to prevent accidents caused by the laser beam. LASER = 780 nm, P max = 5 mW Rating Information: At bottom/rear of the unit. This unit comply with the existing requirements In accordance with the rating plate of the unit, this unit complies with current standards concerning electrical safety and electromagnetic compatibility. [. . . ] The disc that is loaded and ready to play is the icon that is flashing on the display. Sleep Mode You can select the time interval in minutes before the unit turn off automatically. Press SLEEP to select among OFF, 120, 90, 60, 45, 30, 15 and 5 minutes. Notes on CD-R/RW Disc: · Do not affix any type of labels to either side (recordable or labeled side) of a CD-R/RW disc as this may result in the unit malfunctioning. · To avoid damages to the CD-R/RW disc, do not open the disc compartment door while the disc is being read. · Do not load an unrecorded CD-R/RW disc into the unit. This may take a longer time to read the disc. · Playback capability for CD-RW discs may vary due to variations in the quality of the CD-RW disc and the recorder used to create the disc. Setting the Timer 1. Press and hold TIMER until the ON and clock hour flashes on the display ( ON - timer on time ). For setting time, press SKIP BACKWARD or SKIP FORWARD on the main unit or PRESET or PRESET on the remote control to set the hour and then press TIMER to shift to minute digits. Press SKIP BACKWARD or SKIP FORWARD on the main unit or PRESET or PRESET on the remote control to set the minute. Press TIMER to change to OF (timer off time) with clock time flashing. Repeat steps 2 & 3 for timer off time setting. Play and Pause Discs · Press PLAY/PAUSE in stop mode to begin playback. · Press PLAY/PAUSE during playback to to pause disc. Press again to resume. Note: Be sure to remove all discs from the disc compartment before moving or transporting the unit! Play and load simultaneously by: 1. Press DISC OPEN/CLOSE on the front panel of the main unit or OPEN/CLOSE on the remote control to open the tray while a CD is playing. Press DISC OPEN/CLOSE on the front panel of the main unit or OPEN/CLOSE on the remote control to close the tray. 6 7 CD Player EN Selecting a Disc · Press DISC 1, DISC 2, DISC 3, DISC 4, or DISC 5 on the main unit to directly access the corresponding disc. Press the corresponding disc number on the main unit or DISC SKIP to select disc. Press SKIP BACKWARD / SKIP FORWARD on the main unit or TUNING or on the remote control to select track to enter into memory. Repeat steps 2 to 4 to store more tracks into program memory. Radio Selecting Tuner Band 1. Press SOURCE on the main unit or TUNER on the remote control to enter Tuner mode. Press CD INFO/BAND to select Radio band. Auto Preset Programming Press and hold CD INFO/BAND button for 2 seconds to scan stations in FM band. The stations will then be stored as preset channels. Beware of your preset channels being erased accidentally because the scanning and storing process is automatic upon pressing the button. You can stop the automatic scan by pressing any button, but the erased stations cannot be recovered. EN Tip: Your audio system has 32 preset stations. Searching Through a CD · Press SKIP BACKWARD / SKIP FORWARD on the main unit or or on the remote control to skip to the previous or next track. [. . . ] · Never operate this product with the cabinet removed. ·Do not use your System immediately after transporting it from a cold place to a warm place, as condensation may cause the system to malfunction. · Keep your unit away from humid areas and abnormally hot places. · Do not touch the player with wet hands. [. . . ]