User manual THOMSON DPL900VD-LAST

[. . . ] You have requested a title or chapter number or search time that is not available. Video and audio There is no picture ? · Turn on the TV set. · Make the correct input selection on the TV set. TV or video recorder cannot be operated with the remote control. · Not all models can be operated with the supplied universal remote control. No picture or the picture shown is not that of the DVD player. · Switch off the other video device connected to the AV jack of the player. The picture is distorted or shakes during search, forward or reverse. · Search, forward or reverse playback generates a slight distortion, but this is not a malfunction. Playback Playback does not start when the PLAY key is pressed ? · Make sure that the disc (single sided) is loaded correctly with the title label facing up. · Make sure you are in the proper source mode. There is no sound or it can hardly be heard ? · Make sure the speakers are connected. · Make sure the MUTE button is not on. [. . . ] Some DVDs use a multi-camera angle system only in certain portions of the DVD. FM TUNER SECTION: Frequency Response: 40Hz ­ 15kHz +/-3dB Quieting: 24dBu Signal to Noise: 60dB(stereo) / 65dB(mono) Image Ratio: 40dB IF Rejection: 50dB The menu language is not the one you want ? · The menu language for your player has not been set during set-up. · Your preferred menu language on a DVD disc (if available) has not been set during set up. Audio (spoken) and / or subtitle language is not the one selected during the initial player set-up ? · If the audio or subtitle language is not available on the DVD disc, the language selected during initial player set-up will not be heard or seen. The disc's priority language (default language) is selected automatically. If you want another language, press menu during playback, if the disc has its own language selection menu (Refer to page 21). Radio STEREO indicator is off. · Adjust the antenna. The signal is Mono. Severe hum or noise. · The signal is too weak. Connect an external antenna. 41 Care and Maintenance Disconnect the audio system from the power source before performing any maintenance. Safety precautions · Never open the cabinet under any circumstances. Any repairs or internal adjustments should be made only by a trained technician. · Never operate this product with the cabinet removed. · Do not touch the player with wet hands. If any liquid enters the player cabinet, take the player to a trained technician for inspection. · This player uses a laser to read the data on the disc. The laser mechanism corresponds to the cartridge and stylus of a record player. Although this product incorporates a laser pick-up lens, it is completely safe when operated according to directions. · Discs rotate at high speed inside the player. Do not use damaged, warped, or cracked discs. · Do not touch the pick-up lens which is located inside the disc compartment. Also, to keep dust from collecting on the pick-up lens do not leave the compartment door open for an extended period of time. If the lens becomes dirty, clean it with a soft brush, or use an air blower brush designed for camera lenses. Cleaning Clean the exterior of the system using a soft dust cloth. The player CAUTION!It must be opened by only a qualified technician. · Never move the player during playback. [. . . ] · You should use extreme caution or temporarily discontinue use in potentially hazardous situations. · Even if your headset is an open-air type designed to let you hear outside sounds, don't turn up the volume so high that you are unable to hear what is around you. Don't infringe This product should only be used for the purposes for which it is sold, that is, entertainment, violating no copyright law. Any attempts to use this product for which it is not intended is unlawful and therefore not condoned by Thomson multimedia. Disc lens care · When your disc lens gets dirty it can also cause the system to output poor sound and visual quality. To clean the lens you will need to purchase a disc lens cleaner which can maintain the output sound and visual quality of your system. [. . . ]