User manual THOMSON DST61XD

[. . . ] (This page also explains to you where to find this information on your appliance. ) -Carefully follow the instructions contained in this user guide. The manufacturer declines all responsibility for any problems, damage or fire caused by the appliance if failing to observe the instructions contained in this user guide. Keep this user guide with your appliance. [. . . ] This appliance can be installed in either duction version or filtering version. 1) Your hood can be connected to this outlet using a flue (Ø 150mm that is enamelled, in aluminium, flexible or made of inflammable material). USING THE FILTERING MODE If you do not posses an oulet to the exterior (fig. 2) All of our appliances can be used in recycling mode. The air and steam taken up by the unit are purified with charcoal filter and returned to the environment through the aeration grids on the side of the telescopic flue. ELECTRICAL CONNECTIONS During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The electrical connections are made before the appliance is installed in its housing. Ensure that - the electrical installation has sufficient voltage, - the electrical wires are in good condition, - the diameter of the wires complies with the installation requirements. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3mm, such separating device ensuring disconnection from the main must be included in the fixed installation. This appliance is delivered with a H05VVF power cord that has three-0. 75mm2 conductors (neutral , phase and ground). It must be connected to the main power supply (which should be a 230-240V single phase current) via a CEI60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. If the power cable is damaged, call the after-sales service department in order to avoid danger. If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In France these regulations are described in DTU 61. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must be at least 650 mm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account. [. . . ] Remove the grease filter by pushing the catch and turning it outwards (Fig. Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. If the halogen light bulbs need changing, slacken the ring nut in an anticlockwise direction and remove the bulb itself (Fig. CAUTION: Do not handle glass bulb with bare hands. [. . . ]