User manual THOMSON DTI 652

[. . . ] DTI series 652 / 1004 User manual General Information 1. Precautions Never open your set yourself. It could be dangerous and you risk electric shock or damaging the set. Any noticed damage will invalidate the warranty conditions of your equipment. [. . . ] Erase all settings, including PIN code (0000). Set the internal antenna to on/off (off). TV scart output CVBS standard RGB level Overview of all installed TV & radio services. Menu language Audio Preference Channels Parental lock PIN code Erase Channels Information Install all TV & radio. Lock or unlock channels based on maturity information. Change PIN Code. Show terminal & software reference http://www. thomson-europe. com. Note : value set by default is shown under brackets (e. g. ). 5 General Information 4. 1 Channels This sub-menu gives an access to the All channels list. Using p/q buttons, select Channels then press OK. The `All channels' list displays on the left while you can view in a resized video picture on the right the current program of the highlighted channel. This sub-menu allows you to reorganize the All channels list and set a channel protection on some channels. Note: For a direct access the `All channels' list without reorganizing channels, press the WHITE/LIST button, select All channels and press OK. Delete Channels from the channel list (to remove unwished channels): 1. Use the p/q, buttons to select the channel to remove from the list. A red garbage bin displays on the right of the channel name. Press OK button to delete all channels selected with the red garbage bin, or press EXIT to cancel this operation. Move Channels from the channel list (to modify the P+/P- order): 1. Use the p/q buttons to select the channel to reorder in the list. Press the (Green) button to display a green twin-arrow icon on the right of the channel name. Use the p/q buttons to move the selected channel to its new position in the list. Lock/unlock Channels from the channel list (to set/delete a PIN code to view some channels): 1. Use the p/q buttons to select the channel to lock. Press the (Yellow) button to display a yellow lock icon on the right of each channel to lock. Enter the decoder PIN Code to lock all channels selected with a yellow lock icon. Note 1:The procedure to unlock a channel is similar. Note 2: Prior to any PIN Code change, the PIN Code factory setting is `0000'. 3. [. . . ] TV is set to wrong channel. Solution Check that the power cord is plugged into the wall outlet. Check if the TV is switched on and set your TV to the correct EXT / AV or UHF channel. Check if the scart and/or RF cable is connected correctly to the TV and to the back of the receiver. Replace the scart cable Switch off receiver; disconnect the main power cord of the receiver from the 230V mains. After 30 seconds reconnect to the main power and check if it is working properly. [. . . ]