User manual THOMSON DTT61XD

[. . . ] (This page also explains to you where to find this information on your appliance. ) -Carefully follow the instructions contained in this user guide. The manufacturer declines all responsibility for any problems, damage or fire caused by the appliance if failing to observe the instructions contained in this user guide. Keep this user guide with your appliance. [. . . ] - Under no circumstances should the exhaust duct empty into the attic. - Install the hood at safe distance of at least 65 cm from an cooking hob. This appliance can be installed in either duction version or filtering version. 1) Your hood can be connected to this outlet using a flue (minimum Ø 125mm that is enamelled, in aluminium, flexible or made of inflammable material). USING THE FILTERING MODE If you do not posses an oulet to the exterior (fig. 2) All of our appliances can be used in recycling mode. The air and steam taken up by the unit are purified with charcoal filters and returned to the environment. ELECTRICAL CONNECTIONS During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The electrical connections are made before the appliance is installed in its housing. Ensure that - the electrical installation has sufficient voltage, - the electrical wires are in good condition, - the diameter of the wires complies with the installation requirements. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3mm, such separating device ensuring disconnection from the main must be included in the fixed installation. This appliance is delivered with a H05VVF power cord that has three-0. 75mm2 conductors (neutral , phase and ground). It must be connected to the main power supply (which should be a 230-240V single phase current) via a CEI60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. If the power cable is damaged, call the after-sales service department in order to avoid danger. If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In France these regulations are described in DTU 61. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. [. . . ] 7); open the trolley and take off the other filter doing the same. Remove the filters by rotating them and fit them back on by rotating them in the opposite direction (fig. Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. If the halogen lamps need changing, slacken the ring nut in an anticlockwise direction and remove the bulb itself (fig. [. . . ]