User manual THOMSON ROC 1407 CODE

[. . . ] Press and release the "Setup" key followed by the function key you want. : Displays information of the selected appliance. Numeric keys 0-9: These keys have the same functions as those of your original remote and are also used to enter the codes for different products. -/--: In connection with the numeric keys, this button allows you, with some equipment, to select directly channels with 2 digits. [. . . ] If you do not react quickly enough, you can go back to the previous code by pressing Prog- or E (DVD/ VCR only) as many times as necessary (you can go forward by pressing G , Prog+ or B (DVD/ VCR only) if you have gone back too far). As soon as the set responds again, press OK to save the code. ) and the make, you will be required to enter a single code for both devices in the COMBO, or to enter two codes, one code per device. consult the separate list to discover this. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder, . Hold the SETUP key down until the red indicator lamp blinks and then remains lit. Press the key of the first device to control, and then follow one of the programming methods A, B, C or D previously described. If a second code programming is required, then repeat steps 2 and 3 above. If the make of the device you wish to control is not in the separate code list or if some functions are missing in the code you have programmed, you can copy the key functions of the original remote control of the device into your ROC 1407. Depending on the format of the transmission codes of the original remote control, your ROC 1407 remote control can memorise up to 150 keys. Global delete ­ Delete all the keys copied (this is recommended the first time you use this function) 1. If you think that not all of the keys are active, repeat the procedure of this programming method to find out the code supporting a wider range of features. Method D ­ Automatic code search With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Hold down the SETUP key until the red indicator lamp blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key corresponding to the type of equipment (for example TV). After a few seconds, the remote control begins to scroll through the whole code list included in the library (at a rate of roughly 1 code per second). Note: Some original remote controls don't transmit continuous IR signals when a key is held down. If this is the case, press several times on one of the keys while moving the remote control from left to right. Hold down the SETUP key until the red indicator lamp remains lit. Press once on the mode key (TV, DVD, VCR, . Press once on the key of your ROC 1407 to which you want to copy one of the keys of your original remote control. [. . . ] DVD player: load a DVD and then press B. Do not move the remote controls during the learning procedure. Ensure that the room is not lit by fluorescents tubes or low consumption lamps since such light sources can interfere with the copying. The 2 remote controls must be at least one metre away from any light source. [. . . ]