User manual THOMSON ROC 2406

[. . . ] This remote control has been factory programmed to allow you to use it immediately with the majority of Thomson Group devices. We therefore advise you to try it before beginning to program it. If programming is necessary, follow one of the methods A, B, C or D that are given in this manual. Keep these instructions and the separate list of codes in a safe place so that you can later reprogram your remote control. [. . . ] Repeat step 4 to find out the other numbers of the code. Once you have found the fourth digit, the selected mode indicator goes off. For a television or a satellite receiver: switch on and, for example, press 2 to change channels. Video recorder: load a tape and then press · DVD player: load a DVD and then press . After a few seconds the remote control begins to list all the codes included in the library (around 1 a second code per second). Press PROG time to reduce the speed of the test (1 code every 5 seconds). As soon as the device changes channel you must immediately press OK to record the code and stop the listing. If you don't react quickly enough, simply return to (you the previous code by pressing PROG can restart the forward listing by pressing PROG . As soon as the device reacts again, press OK to record the code. Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. If the make of the device you wish to control is not in the separate code list, you can copy the key functions of the original remote control of the device into your ROC 2406. Depending on the format of the transmission codes of the original remote control, your ROC 2406 remote control can memorise up to 150 keys Global delete ­ Delete all the keys copied (this is recommended the first time you use this function) Hold down the SETUP key until the key corresponding to the last selected mode remains lit. The mode key goes out after several seconds. The batteries in the 2 remote controls must be in good condition; change them if necessary. Press the MACRO key once and, within 20 seconds, press the A, B, or C key you used to memorise the sequence. Lay out the original remote control and your ROC 2406 end to end so as to align the LED diodes on the 2 remote controls. Where necessary adjust the height of both remote controls so that the LED diodes are properly aligned. First copy 2 or 3 keys from the original remote control in order to check the compatibility of the codes of both remote controls. Then carry out a global delete of these keys before starting the full learning procedure. The keys L1 to L4 allow you to copy 4 additional keys. Note: when running a Macro (which takes a few seconds), ensure that the remote control is aimed at the device being controlled. [. . . ] Hold down the SETUP key until the key corresponding to the last selected mode remains lit. Press the key until the mode key blinks once. The THOMSON NAVILIGHT system allows you easy access to the settings of your television (TV) or video recorder (VCR) including this feature. Press the key corresponding to the type of set you want to use (TV, VCR, or SAT). [. . . ]