User manual THOMSON ROC 3404

[. . . ] i/EXIT: Teletext Off in TV mode; turns off the menu of the selected product (SHIFT + EXIT). PROG+/-: Programmes zapping button (rapid select); use to scroll vertically through menus (SHIFT + PROG+/-). s/SHIFT: Programmes the remote control (S) or activates the secondary key features (SHIFT). 3: Press this key first before you type in the 2-digit channel number (except for Thomson group products). [. . . ] Turn on the product you want to control. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player. While the indicator is lit, enter the 3-digit code proposed for the product to be controlled (example: 036 for THOMSON). The red indicator then goes off if the code is correct or flashes, if the code is not on the list. Point the remote control towards the product and try to turn it off by pressing the B key (11). If the product doesn't turn off, repeat step 2, using the next 3-digit code in the list. Try to turn off the product by pressing B key (11) once. Repeat this procedure until one of the 3-digit codes works. Checking the programming: Your product should be ready to receive remote control commands. As soon as the product responds again, press OK (8) to save the code. Note: If you want to assign another type of product than those mentioned on the remote control, begin by entering a code that corresponds to the product you want to programme (a 3-digit code that you will find in the code booklet ­ see method B). Example: if you want to control a satellite receiver with the VCR key, begin by entering a satellite code (any satellite, for example: 603 for a Thomson satellite receiver) then begin the procedure. Checking the programming: Your product should be ready to receive remote control commands. To set up the remote control to control a COMBO you first programme the television and then the video recorder subset. Before you start programming, you must find the subcode or code of the combo to be controlled (television or video recorder). Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the TV key (2), then follow one of the programming methods (A, B, C or D) described earlier. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). [. . . ] The indicator light will blink and then go off for about 8 seconds before blinking once more and then staying off. If the remote previously controlled the television volume in SAT mode, it will now control the volume of the satellite receiver; if it previously controlled the volume of the satellite receiver, it will now control the television volume. The THOMSON NAVILIGHT system allows you easy access to the settings of your television (TV) or video recorder (VCR). In the VCR position, make sure that the AV mode is activated for the TV set (the SCART socket must be selected). [. . . ]