User manual THOMSON ROC 36

[. . . ] If you are not using the remote control for a long period of time, remove the batteries. please respect the environment and prevailing regulations. Before you dispose of batteries or accumulators, ask your dealer whether they are subject to special recycling and if they will accept them for disposal. It can replace 6 remote controls thanks to its 6 mode keys TV, DVD, VCR, . [. . . ] Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit. Press the key that corresponds to the type of equipment you want to control: TV: television set - DVD: DVD player - VCR: video cassette recorder - SAT: satellite - CBL: cable - AUDIO: Hifi system - AUX: other devices. With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit (the indicator lamp remains lit for several seconds in order to let you continue with the following steps. The blinking of the indicator indicates the end of the available time, then it goes out). Press the numbered keys in ascending order (0 to 9) until the selected mode blinks once. The number that caused the selected mode to blink is the first of the three numbers that make up your code. Repeat step 4 to find out the two other numbers of the code. When the third number has been found, the indicator light for the selected mode goes out. Press the key corresponding to the type of equipment (for example TV). After a few seconds the remote control begins to list all the codes included in the library (around 1 a second code per second). If the make of the device you wish to control is not in the separate code list, you can copy the key functions of the original remote control of the device into your ROC 36. Depending on the format of the transmission codes of the original remote control, your ROC 36 remote control can memorise up to 150 keys Press and hold down the SETUP key until the mode key blinks (TV, VCR, . Press once the A, B, or C key which you are going to use to memorise the sequence. ) mode key of the first device you wish to control (the first key must always be a mode key. Successively press the keys corresponding to the commands you wish to send to the device(s) (9 keys maximum, including other mode keys). The mode key blinks when each key is pressed. Memorise your key sequences by pressing the MACRO key once. The mode key is no longer lit and your Macro is complete. Note: a sequence will be automatically memorised after the tenth key press (counted from the mode key) and the mode key light will go out. Global delete ­ Delete all the keys copied (this is recommended the first time you use this function) 1. Hold down the SETUP key until the key corresponding to the last selected mode remains lit. [. . . ] Press the key until the mode key blinks once. ) corresponding to the device whose volume will always be controlled by the VOL and keys. Hold down the SETUP key until the key corresponding to the last selected mode remains lit. The HOME CINEMA key has now been deprogrammed. [. . . ]