User manual THOMSON ROC 4206

[. . . ] 10 Operating indicator: lights up when a key is activated and remains fixed or flashes during programming. *** The coloured buttons can be used to select categories when teletext is activated, and specific functions depending on the make. Point the remote control at the device you wish to control and try to turn it off using the B key. If the device does not turn off, you must program the remote control using one of the methods A, B, C or D as described below. [. . . ] Press the key corresponding to the type of equipment (for example TV). After a few seconds the remote control begins to list all the codes included in the library (around 1 code per second). Press PROG+ a second time to reduce the speed of the test (1 code every 3 seconds). As soon as the device changes channel you must immediately press c to record the code and stop the listing. If you have gone past the code, you can go back to the previous code by pressing PROG- as many times as necessary (you can go forward by pressing B or PROG+. As soon as the device reacts again, press c to record the code. Note: If you want to assign another type of product than those mentioned on the remote control, begin by entering a code that corresponds to the product you want to programme (a 4-digit code that you will find in the code booklet ­ see method B). Example: if you want to control a satellite receiver with the DVD/VCR key, begin by entering a satellite code (any satellite, for example: 0603 for a Thomson satellite receiver) then begin the procedure. ) and the make, you will be required to enter a single code for both devices in the COMBO, or to enter two codes, one code per device. consult the separate list to discover this. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder). Method C ­ Programming by means of code retriever Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the SETUP until the red indicator lamp remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Direct the remote control towards the set and try to switch it off by pressing the B key. If the set you want to control switches off, press c to memorise the subcode. Should the set not switch off, press B key, as many times as required (up to 200 times), until the set switches off. Wait approximately one second between key presses to give the red indicator lamp enough time to go off and light up again. Proceeding this way will enable you to see whether the set responds or not. Hold down the SETUP until the red indicator lamp remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the TV key, then follow one of the programming methods (A, B, C or D) described earlier. [. . . ] ) og merke, kommer du til å taste inn én enkelt kode for de to apparatene i Combo'en eller taste inn to underkoder, én kode per apparat. ENGLISH - Do not mix different types of batteries or new and old batteries. In order to avoid any risk of explosion, observe polarities indicated inside the battery compartment. replace only with the type of batteries specified above. [. . . ]