User manual THOMSON ROC 4406B

[. . . ] Method A ­ Fast programming with 1-digit subcode Before you start programming, you must find the subcode of the set to be controlled. Hold down the SETUP key until the red indicator lamp remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the key that corresponds to the type of equipment you want to control: TV, DVD/VCR. [. . . ] Try to switch off the set by pressing B key once. Repeat this procedure by trying out each of the 4-digit codes. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 3. Note: If you want to assign another type of product than those mentioned on the remote control, begin by entering a code that corresponds to the product you want to programme (a 4-digit code that you will find in the code booklet ­ see method B). Example: if you want to control a satellite receiver with the DVD/VCR key, begin by entering a satellite code (any satellite, for example: 0603 for a Thomson satellite receiver) then begin the procedure. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 3. Method D - Automatic code search With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Hold down the SETUP until the red indicator lamp remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). If a second code programming is required, then repeat steps 2 and 3 above. Adjustment of ALL volume controls under a specific mode You can allocate the volume control to one of the modes of the remote control on condition that the volume control exists on the corresponding device (e. Hold down the SETUP key until the red indicator lamp remains lit. Press once on the mode key (TV, DVD/VCR. ) corresponding to the device whose volume will always be controlled by the VOL and c keys. Adjustment of the volume controls for EACH mode You can decide that the volume control is functional for each mode selected on condition that the volume control exists on the corresponding device (e. Control of the television set sound in TV mode, the control of the sound of the SAT receiver in SAT mode, . Hold down the SETUP key until the red indicator lamp remains lit. Press once on the mode key (TV, DVD/VCR. ) corresponding to the device whose volume will always be controlled by the VOL and c keys. Hold down the SETUP until the red indicator lamp remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. [. . . ] Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. When you have retrieved the code of your set, jot it down so that you can use it whenever needed. After battery replacement, you may have to programme the remote control again. [. . . ]