User manual THOMSON ROC 4407

[. . . ] Direct the remote control towards the TV set and try to switch it off by simply pressing the key B (1). Should the set not switch off, you'll have to programme the remote control by means of one of the methods A, B, C or D described hereinafter in chapter 3. This Universal Remote Control is compatible with most models of infrared-controlled TV sets and video recorders. Before you start programming, you must find the subcode of the set to be controlled (TV set or video recorder). [. . . ] The indicator lamp flashes to signal that this time is almost up, and then goes off). Direct the remote control towards the set and try to switch it off by pressing the key B (1). Should the set not switch off, press key B (1) repeatedly, until the set switches off. Between two subsequent key depressions, give the red indicator lamp (11) enough time to extinguish and light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Check of the programming In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. Before you start programming, you must find the code of the set to be controlled (TV set or video recorder). Hold down the key SHIFT (4) until the red indicator lamp (11) remains lit. The indicator lamp remains on for a couple of seconds, so that you have time enough to proceed with step 4. The indicator lamp flashes to signal that this time is almost up, and then goes off. Set the remote control selector (13) on VCR, and then proceed with one of the programming methods A, B or C described above. Hold down the key SHIFT (4) until the red indicator lamp (11) remains lit. Press the number keys (0 to 9) in ascending order until the red indicator lamp (11) flashes once. The digit which made the red indicator lamp (11) flash, is the first number of the 3-digit code. Repeat step 4 to find out the two other numbers of the code. When the third number is found, the red indicator lamp (11) goes off. - For a TV set: press for instance number key 2 to switch over to another channel or to switch the set on, in case it is off. - Video recorder: load a tape and then press B. Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. When you have retrieved the code of your set, jot it down so that you can use it whenever needed. [. . . ] When you have retrieved the code of your set, jot it down so that you can use it whenever needed. The THOMSON NAVILIGHT system allows you easy access to the settings of your television (TV) or video recorder (VCR) including this feature. In the VCR position, make sure that the AV mode is activated for the TV set (the SCART socket must be selected). Press the SHIFT key once and then menu (6). [. . . ]