User manual THOMSON ROC 4505

[. . . ] It can replace 4 remote controls thanks to its 4 mode keys TV, DVD, VCR, . It is compatible with the majority of television sets, video cassette recorders, DVD players, satellite and cable receivers as well as terrestrial digital television (DVBT), amplifiers and other audio equipment provided they are controlled by infra red signals. It has 4 additional function keys (L1 to L4) that can be used as additional device keys. It incorporates a home cinema mode that transforms your installation by bringing together virtually all devices and considering them as a single device, each part of the remote control then controls parts of this ensemble. [. . . ] consult the separate list to discover this. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder). Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit. When you have retrieved the code of your set, jot it down so that you can use it whenever needed. Press the key of the first device to control, and then follow one of the programming methods A, B, C or D previously described. The MACRO key in coordination with one of the keys A, B, or C allows the programming and memorisation of up to 3 command sequences (the automatic and successive pressing of several keys of your choice). Thus any sequence of key commands can be reduced to merely 2 commands (MACRO key + A, B, or C key). For example after programming, by pressing MACRO then key A you could turn on your television set, turn on your satellite or cable receiver, zap to a preferred channel, turn on your video cassette recorder and start a recording session (providing a cassette was previously loaded). You can memorise a sequence of 10 commands with each A, B, or C key. If a second code programming is required, then repeat steps 2 and 3 above. Note: during the programming of a macro, the time between each step is limited to a few seconds. This leaves little time for reading the instructions and then carrying them out. If the mode indicator light blinks and then goes out, it is because this time limit has been exceeded, you must start again from step 1. Press and hold down the SETUP key until the mode key blinks (TV, VCR, . Press once the A, B, or C key which you are going to use to memorise the sequence. ) mode key of the first device you wish to control (the first key must always be a mode key. Successively press the keys corresponding to the commands you wish to send to the device(s) (9 keys maximum, including other mode keys). The mode key blinks when each key is pressed. Memorise your key sequences by pressing the MACRO key once. The mode key is no longer lit and your Macro is complete. Note: a sequence will be automatically memorised after the tenth key press (counted from the mode key) and the mode key light will go out. If the make of the device you wish to control is not in the separate code list, you can copy the key functions of the original remote control of the device into your ROC 4505. [. . . ] In the VCR position, make sure that the AV mode is activated for the TV set (the SCART socket must be selected). Navigate through the setting menus with the play keys . To leave the menus, press key EXIT once. The group keys can be programmed in any order. [. . . ]