User manual THOMSON ROC 56

[. . . ] Number keys 0 to 9: these keys have the same functions as those of your original remote and are also used to enter the codes for different products. F (FF) : fast forward for VCRS and DVDS; press with blue key for fast text function in TV mode. B (PLAY): plays a VCR tape or DVD disk; press with yellow key for fast text function in TV mode. K (PAUSE): Suspends play and stops on an image; press with magenta key for fast text function in TV mode. [. . . ] Repeat this procedure until one of the 3-digit codes works. Checking the programming: Your product should be ready to receive remote control commands. If none of the codes work, you may still be able to retrieve the appropriate code. Turn on the product you want to control. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other product. Point the remote control towards the product and try to turn it off by pressing the B key (11). If the product you want to control turns off, press OK (8) to save the subcode. If the product does not turn off, press the B key (11) until the product switches off (up to 200 times). Wait approximately one second between key presses to give the red indicator lamp (1) enough time to go off and light up again. This will allow you to see whether the product responds or not. Immediately upon turning off the product to be controlled, press OK (8) to save the code. Note: When programming the AUX key (to control any type of product) begin by entering a code that corresponds to the product you want to programme (a 3-digit code that you will find in the code booklet ­ see method B). Example: if you want to control a satellite receiver with the AUX key, begin by entering a satellite code (any satellite, for example: 603 for a Thomson satellite receiver) then begin the procedure. Checking the programming: Your product should be ready to receive remote control commands. With this method, the remote scrolls through the full code list by sending an IR signal to the product to be controlled remotely. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) corresponding to the type of product you want to control: (for example TV). After a few seconds, the remote begins to scroll through the code list at approximately 1 code per second. Press PROG+ (16) once again to slow down the test speed (1 code every 3 seconds). [. . . ] The indicator lamp flashes when this time is almost up, and then goes off). The indicator light will blink and then go off for about 8 seconds before blinking once more and then staying off. If the remote previously controlled the television volume in SAT mode, it will now control the volume of the satellite receiver; if it previously controlled the volume of the satellite receiver, it will now control the television volume. The THOMSON NAVILIGHT system allows you easy access to the settings of your television (TV) or video recorder (VCR). [. . . ]