User manual THOMSON ROC 6505

[. . . ] ENGLISH - Do not mix different types of batteries or new and old batteries. In order to avoid any risk of explosion, observe polarities indicated inside the battery compartment. replace only with the type of batteries specified above. Do not throw them into fire, do not recharge them. [. . . ] If you don't react quickly enough, simply return to (you the previous code by pressing PROG can restart the forward listing by pressing PROG . As soon as the device reacts again, press OK to record the code. For a television or a satellite receiver: switch on and, for example, press 2 to change channels. Video recorder: load a tape and then press · DVD player: load a DVD and then press . ) and the make, you will be required to enter a single code for both devices in the COMBO, or to enter two codes, one code per device. consult the separate list to discover this. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder). Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit. Press the key of the first device to control, and then follow one of the programming methods A, B, C or D previously described. Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. When you have retrieved the code of your set, jot it down so that you can use it whenever needed. The MACRO key in coordination with one of the keys A, B, or C allows the programming and memorisation of up to 3 command sequences (the automatic and successive pressing of several keys of your choice). Thus any sequence of key commands can be reduced to merely 2 commands (MACRO key + A, B, or C key). For example after programming, by pressing MACRO then key A you could turn on your television set, turn on your satellite or cable receiver, zap to a preferred channel, turn on your video cassette recorder and start a recording session (providing a cassette was previously loaded). You can memorise a sequence of 10 commands with each A, B, or C key. If a second code programming is required, then repeat steps 2 and 3 above. Note: during the programming of a macro, the time between each step is limited to a few seconds. This leaves little time for reading the instructions and then carrying them out. If the mode indicator light blinks and then goes out, it is because this time limit has been exceeded, you must start again from step 1. If the make of the device you wish to control is not in the separate code list, you can copy the key functions of the original remote control of the device into your ROC 6505. Depending on the format of the transmission codes of the original remote control, your ROC 6505 remote control can memorise up to 150 keys Press and hold down the SETUP key until the mode key blinks (TV, VCR, . [. . . ] notes: · During the programming of the HOME CINEMA, key, any action on the FAV, MACRO keys, or mode keys (TV, DVD, . The group keys can be programmed in any order. The remote control remains in programming mode as long as the HOME CINEMA key is not pressed again. You can decide that the volume control is functional for each mode selected on condition that the volume control exists on the corresponding device (e. [. . . ]