User manual THOMSON ROC 850 AVEC CODES

[. . . ] SHIFT + EXIT: turns off the menu of the selected product. K: Suspends play and stops on an image*. Press this key first before you type in the 2-digit channel number (except for Thomson group products). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, DVD: DVD player, SAT: satellite receiver. [. . . ] Turn on the product you want to control. Hold down the SETUP (11) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, DVD: DVD player, SAT: satellite receiver. While the indicator is lit, enter the 3-digit code proposed for the product to be controlled (example: 036 for THOMSON). The red indicator then goes off if the code is correct or flashes, if the code is not on the list. Point the remote control towards the product and try to turn it off by pressing the POWER (12) key. If the product doesn't turn off, repeat step 2, using the next 3-digit code in the list. Try to turn off the product by pressing POWER (12) key once. Repeat this procedure until one of the 3-digit codes works. Checking the programming: Your product should be ready to receive remote control commands. Example: if you want to control a satellite receiver with the DVD key, begin by entering a satellite code (any satellite, for example: 603 for a Thomson satellite receiver) then begin the procedure. Method E - Programming for control of a COMBO TV/VCR, TV/DVD) Depending on the COMBO group (TV/VCR, VCR/DVD, etc. ) and the make, you will be required to enter a single code for both devices in the COMBO, or to enter two codes, one code per device. Consult the separate list to discover this. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder). Refer to the list supplied with this user manual (see page subcodes or codes). EN 2 1. Hold down the SETUP (11) key until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the TV (2) key, then follow one of the programming methods (A, B, C or D) described earlier. If second code programming is required then repeat steps 2 and 3 above. 6 - Controlling volume in satellite and cable mode For satellite systems with a volume control, you can choose the product that the MUTE (15) and VOL (4) keys will control: the television volume or the volume of the satellite or cable receiver. Press the TV (2) key (the remote control must be in TV mode for this procedure). Hold down the SETUP (11) key until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. [. . . ] If this light goes out, you have to press the SHIFT key again before using the navigation keys. To exit this mode, press SHIFT a second time. 5 - Check the programming - For a television or a satellite receiver: turn on and off, then try to change channels using a digit key (9). - DVD player: load a DVD and then press PLAY (B) (18). Try other remote control keys to find out which functions you can control. [. . . ]