User manual THOMSON ROC Z407 CODE

[. . . ] Note: When programming the AUX key or if you want to assign another type of set than those mentioned on the remote control, for example a satellite code in VCR mode, begin by entering a code that corresponds to the set you want to programme (a 3-digit code that you will find in the code booklet, see method B). Then begin the automatic search (method D). Example: if you want to control a satellite receiver with the AUX key, begin by entering a satellite code (any satellite code that you find in the code list, for example: 603 for a Thomson satellite receiver) then begin the automatic search procedure. the remote control will then test all the satellite codes for the selected make. [. . . ] Try to switch off the set by pressing key B (17) once. Repeat this procedure by trying out each of the 3-digit codes. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the S (6) key until the key that corresponds to the last mode you selected blinks 3 times and then remains lit. Press the key (15) that corresponds to the type of equipment you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other set 4. Direct the remote control towards the set and try to switch it off by pressing the key B (17). If the set you want to control switches off, press OK (2) to memorise the subcode. Should the set not switch off, press key B (17) as many times as required (up to 200 times), until the set switches off. Between two key presses, leave enough time for the key corresponding to the selected mode enough time to light up again (about 1 second). Hold down the S (6) key until the key that corresponds to the last mode you selected blinks 3 times and then remains lit. Press the TV (15) key, then follow one of the programming methods (A, B, C or D) described earlier. Hold down the S (6) key until the key that corresponds to the last mode you selected blinks 3 times and then remains lit. Press the VCR (15) key, then follow one of the programming methods (A, B, C or D) described earlier. Hold down the S (6) key until the key that corresponds to the last mode you selected blinks 3 times and then remains lit. Press the key (15) that corresponds to the type of equipment you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other set 3. Press the numbered keys in ascending order (0 to 9) until the selected mode blinks once. The number that caused the selected mode to blink is the first of the three numbers that make up your code. Repeat step 4 to find out the two other numbers of the code. When the third number has been found, the indicator light for the selected mode goes out. - For a television or a satellite receiver: switch on and, for example, press 2 to change channels. [. . . ] Press the TV key (the remote control must be in TV mode for this procedure). Hold down the S (6) key until the last mode selected (TV) blinks 3 times and then remains lit. Press the MUTE (21) key for around 8 seconds. The TV mode indicator light will blink and go out for about 8 seconds before blinking once; at this point, release the MUTE (21) key. [. . . ]