User manual THOMSON ROC 3407 CODE

[. . . ] Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 2. Direct the remote control towards the TV set and try to switch it off by simply pressing the key G. If the device does not turn off, you must program the remote control using one of the methods A, B, C or D described hereafter. [. . . ] Before you start programming, you must find the code of the set to be controlled. Hold down the SETUP key until the red indicator light blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). While the indicator is lit, enter the first digit of the 4-digit code proposed for the set to be controlled (example: 0036 for Thomson). Direct the remote control towards the set and try to switch it off by pressing the key G. Should the set not switch off, repeat step 2. Try to switch off the set by pressing key G once. Repeat this procedure by trying out each of the 4-digit codes. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 2. The indicator lamp flashes to signal that this time is almost up, and then goes off). After a few seconds, the remote control begins to scroll through the whole code list included in the library (at a rate of roughly 1 code per second). Press the P+ , G key once again to slow down the test speed (1 code every 3 seconds). As soon as the set changes channels (or turn off, or start to play the disk), you must press OK to save the code and stop the remote control scrolling through the list. If you do not react quickly enough, you can go back to the previous code by pressing P- as many times as necessary (you can go forward by pressing G , P+ if you have gone back too far). As soon as the set responds again, press OK to save the code. Hold down the SETUP key until the red indicator light blinks and then remains lit. Press the SETUP key again briefly, the indicator light blinks once. Press the number keys (0 to 9) until you notice that the indicator lamp blinks once. The number which made the indicator lamp blink is the first of the four figures comprising your code, write it down. [. . . ] The number which made the indicator lamp blink is the first of the four figures comprising your code, write it down. Repeat step 3 to find out the 3 other numbers of the code. When the fourth figure is found, the indicator lamp goes out. Conservez cette notice et la liste des codes séparée afin de pouvoir reprogrammer ultérieurement la télécommande pour commander d'autres appareils. [. . . ]