User manual THOMSON ROC6306

[. . . ] Hold down the SETUP key until the red indicator light blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key that corresponds to the type of equipment you want to control: TV: Television Set, DVD: DVD Player, Video Recorder, VCR, AUX, SAT: Satellite Receiver, Cable Receiver, ADSL Box, DVBT Receiver, . Direct the remote control towards the set and try to switch it off by pressing the key G. [. . . ] For this reason, we recommend that prior to attempting to programme the remote control, you try it out by means of one of the methods described in this user manual. However, first of all, you must install 2 batteries (AAA) in the remote control. Please keep this guide along with the code list (provided separately), so that you can subsequently programme your remote control for use with other sets. While the indicator is lit, enter the first digit of the 4-digit code proposed for the set to be controlled (example: 0036 for Thomson). Direct the remote control towards the set and try to switch it off by pressing the key G. Should the set not switch off, repeat step 2. Try to switch off the set by pressing key G once. Repeat this procedure by trying out each of the 4-digit codes. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 2. Method C ­ Programming by means of code retrieval Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. consult the separate list to discover this. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder. Hold the SETUP key down until the red indicator lamp blinks and then remains lit. Press the key of the first device to control, and then follow one of the programming methods A, B, C or D previously described. If a second code programming is required, then repeat steps 2 and 3 above. Placing all devices on standby Press the G key twice in less than one second, keeping it held down the second time. All the devices go on standby one after the other (the devices which were already on Standby may turn on). Adjustment of ALL volume controls under a specific mode In its delivered state, the ROC6306 is programmed such that all modes will use their own Volume and Mute functions if present. You can allocate the volume control to one of the modes of the remote control on condition that the volume control exists on the corresponding device (e. Hold the SETUP key down until the red indicator lamp blinks and then remains lit. ) corresponding to the device whose volume will always be controlled by the VOL and H keys. [. . . ] The number which made the indicator lamp blink is the first of the four figures comprising your code, write it down. Repeat step 3 to find out the 3 other numbers of the code. When the fourth figure is found, the indicator lamp goes out. For a television or a satellite receiver: switch on and, for example, press 2 to change channels, etc. [. . . ]