User manual THOMSON RR420CD

[. . . ] To cut the power supply off, the power cable must be unplugged. Safety Information CAUTION! Invisible laser radiation when open. This system must be opened only by qualified technicians to prevent accidents caused by the laser beam. LASER = 780nm, P max=5 mW Rating Information : At the bottom of the unit. This unit complies with the existing requirements. [. . . ] Remove battery compartment door (located at the bottom of the radio) by applying thumb pressure to area indicated on battery door and then lift the door out and off the cabinet. Connect a 9V battery to the connector plug. Insert battery in the compartment and replace the compartment door. Power Failure Indicator When the AC power is interrupted (disconnected) for a short period of time, both time and alarm settings will change (unless optional battery is installed). After AC power is restored (reconnected), the Digital Display will blink to indicate that power was interrupted and you should re-adjust the time and alarm settings. EN The descriptions and characteristics in this owner's manual are for the purpose of general reference only and not as a guarantee. In order to provide you with the highest quality product, we may make changes or modifications without prior notice. The English version serves as the final reference on all product and operational details should any discrepancies arise in other languages. 3 Operating the Clock EN Setting time: 1. Press the SET button, the " : " will flash on the display . Press REV Tip: Tip No icon will be flashing if all selectors are set, if you see any icon flashing on display, press the SET button repeatedly to confirm everything is set correctly. 4 Operating the Radio EN FM MW TUNING MW / FM Tuning the Stations 1. Slide the MW/FM switch to the desired broadcast band. Turn the TUNING knob to select a station. Press OFF to turn off the radio. Antennas MW antenna - A built-in ferrite rod antenna eliminates the need for an outside antenna for MW reception. Rotating the unit slightly may improve the reception of distant MW stations. FM antenna - The power cord acts as your FM antenna. It picks up moderate to strong stations and eliminates the need for an external antenna in most strong signal areas. Be sure the power cord is stretched to its full length. Changing position of the power cord may improve reception. You may try to move the power cord in order to improve the reception. Built-In AFC The Built In Automatic Frequency Control (AFC) works only on FM. It helps reducing drift on FM reception and keeping the radio locked in on the FM station to which it is tuned. When tuning in FM stations, you may notice that the station you are tuning can be well-tuned on two or three nearby points on the dial. Always tune carefully at the loudest and clearest point. 5 Operating the CD player EN Listening to compact disc 1. When there is no disc in the CD compartment, "nd" will show on display. Selecting play mode 1. During playback, press CD MODE to toggle between different play mode. [. . . ] Press ALARM 1 or ALARM 2 within 3 seconds to deactivate the corresponding alarm function permanently. You can activate the previously set alarm time by pressing ALARM 1 or ALARM 2. 8 Operating the Clock Radio Snooze Alarm Operation This operation allows extra sleep time after the alarm is on. The alarm will turn off by pressing SNOOZE until the snooze period is over. Snooze function can be used repeatedly up to 2 hours. [. . . ]