User manual THOMSON RR520U

[. . . ] USYNLIG LASERSTRÅLNING VED ÅBNING NAR SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION. UNGDÅ UDSAETTELSE FOR STRÅLNING. UNSICHTBARE LASERSTRALUNG WENN ABDECKUNG GEÖFFNET UND SICHERHEITS­ VERRIEGELUNG ÜBERBRÜCKT. NICHT DEM LASERSTRAHL AUSSETZEN! EN CAUTION ­ INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS FAILED OR DEFEATED. [. . . ] 6 Care and Maintenance 13 NOTE: Alkaline (6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be used but memory holding time will be substantially reduced. Memory holding time for a fresh alkaline battery is approximately 8 hours (if radio or alarm are not operated) which should take care of short, nuisance-type AC power failures. To preserve battery life, the unit should remain plugged into an AC outlet. As the battery gets older, its voltage drops and memory may be lost. Be sure to replace the battery periodically. Battery should be removed if the unit will be stored for more than one month. Leaky battery can badly damage the clock radio. 1 RR520U EN rev. 1 4-5 9/10/02, 6:00 PM THE DIGITAL CD CLOCK RADIO Have a Blast- Just Not in Your Eardrums!Make sure you turn down the volume on the unit before you put on headphones. Increase the volume to the desired level only after headphone is in place. Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling. THE DIGITAL CD CLOCK RADIO To set clock and wake time, slide the selector switch on the top of the unit to select between setting LOCK, AL1, AL2 and CLOCK. EN Setting time 1 1 2 Slide the selector switch to CLOCK. 2 Press TUNING TIME DN or UP to select current time. The Display NOTE: NOTE 1. to adjust to the desired wake-up volume. to turn off the unit. 1 2 2 5 Turn Press OFF Stopping alarm 1. To silence the alarm momentarily: · 1Press SNOOZE and the alarm will sound again when the snooze period is over (see "Adjusting snooze duration" above) 2. To stop alarm from sounding: · Press OFF 2 time. and the alarm will be on again the following day at the same 6 · If the CD compartment is empty, the alarm tone will sound instead when in fact WAKE TO CD mode is selected. · When setting AL2, same procedure is followed. Alarm will still sound when it is activated even if headphone is inserted. When you adjust the alarm time in wake off mode, the alarm will automatically be activated. 3. 3 To cancel alarm completely: · Press CANCEL then AL. 1 or AL. 2 and the corresponding 4 alarm(s) won't sound again the following day. · 5 If you press AL. 1 or AL. 2 button again, the previous preset time remains unchanged. · If uninterrupted, the alarms will stop sounding in 2 hours. 6 7 RR520U EN rev. 1 10-11 9/10/02, 6:00 PM THE DIGITAL CD CLOCK RADIO Setting NAP Duration You may take a short nap and be woken up by the alarm. 1 THE DIGITAL CD CLOCK RADIO Listening to radio Slide the selector switch to the LOCK wake settings to access radio funtions. 4 3 EN position after clock or 1 Press NAP on the top of the unit. 2 3 4 3 The NAP indicator flashes and 0:20 (as default setting) will appear on the display. Display will switch back to real clock time after about 3 seconds. Before display switches back to clock time, press TUNING/TIME DN or UP to set nap time. [. . . ] Press PLAY . 3 4 3 3 Press MEMO SET to confirm your settings. Adjust to your desired listening level. TIPS: Maximum 11 (10 preset locations and 1 alarm memory location) preset stations can be stored. You can also overwrite preset station numbers by pressing MEMO SET to enter setting mode. Press RECALL select the number and press MEMO SET again to confirm selection. to If the unit contains no CD, the display will show "nd" when you press PLAY and then revert back to clock time. Cancel Memory 1 1 Press TUNING/TIME DN or UP select track. [. . . ]