User manual THOMSON RR60

[. . . ] To cut the power supply off, the power cable must be unplugged. RR60 EN 1 9/10/02, 5:28 PM Safety Information TECHNICAL SPECIFICATIONS: Power supply AC 230V ~50Hz Clock:9V 6F22 Power consumption: 4W EN Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling. Do not place the system near wet areas such as bathrooms and pool side. Do not expose this appliance to rain or moisture Avoid storing the system at humid places or near abnormally heated areas. Power is continuously supplied to the system. [. . . ] As batteries get older, their voltage drops and memory may be lost. Be sure to replace the battery periodically. Battery should be removed if the radio will be stored for more than one month. Leaky batteries may badly damage the clock radio. 2 RR60 EN 3 9/10/02, 5:28 PM Operating the Radio EN Tuning the Stations 1. Plug the power cord into any 230V AC household outlet. Press ON/OFF (located on the top of the radio) to turn on the radio. Slide the FM/MW(RR60M/Q only, FM/ LW for RR60L) switch to the desired broadcast band. Press ON/OFF to turn off the radio radio locked in on the FM station to which it is tuned. When tuning FM stations, you may notice that the station you are tuning can be well-tuned on two or three nearby points on the dial. Always tune carefully at the loudest and clearest point. Built-In AFC The Built In Automatic Frequency Control (AFC) works only on FM. It helps reducing drift on FM reception and keeping the Notes: RR60Q is a built-in Quartz version, recommended to use in eastern European countries. 3 RR60 EN 4 9/10/02, 5:28 PM Operating the Clock EN Rev Setting Clock Time Your digital clock operates on a 24-hour standard mechanism. When you press and hold REV or FWD, the time decrements or increments will follow by a fast rate. No adjustment can be made when LOCK mode is selected. The time decrements or increments will follow by a faster rate when you press and hold either REV or FWD. A blinking red indicator is activated. Note: The unit equips with GRAD-UWAKE feature, the alarm tone volume will increase gradually to its maximum in about 30 to 45 seconds. (Volume level cannot be adjusted in GRAD-U-WAKE mode) Tips: If you set SLEEP function with low volume level before going to bed, we advise using BUZZER mode to wake you up since its volume will automatically increase. Setting the ALARM Time This clock radio has one alarm, the setting procedures are as follow: 1. Press REV or FWD to set the alarm time. 4 RR60 EN 5 9/10/02, 5:28 PM Operating the Clock Sleep Mode In sleep mode, the radio will turn off automatically. Press SLEEP then the time display will exhibit 0:59 and the radio will turn on. While holding SLEEP, press REV or FWD to set the sleep time. The time range is from 1 minute to 2 hours. Release SLEEP and the current time will be shown again. The radio is turned on and you may select the station as usual. The radio will turn off when the preset time elapses. If you decide to turn off the radio sooner, press SNOOZE or ON/OFF. [. . . ] Release button, then, the "quiet" period is set. Notes: 1. Press and hold NAP to cancel the nap setting. Nap alarm is equipped with GRAD-U-WAKE feature. If the radio is currently on(by pressing the ON/OFF button), then the radio will be on after NAP is pressed. Turning off Alarm Silence the alarm momentarily Press SNOOZE. [. . . ]