User manual THOMSON RR640CD

[. . . ] EN Safety Information EN CAUTION: For UK Only CONNECT THE MAIN LEAD INTO AC MAINS POWER SOCKET POWER SUPPLY 230V. Note: The mains lead of the set is fitted with a moulded plug. If the mains socket are not compatible or if for any reason the plug is removed please follow the directions below. The moulded plug cannot be rewired and if removed must be disposed of safely. [. . . ] To preserve battery life, the unit should remain plugged into an AC outlet. As the battery gets older, its voltage drops and memory may be lost. Be sure to replace the battery periodically. Battery should be removed if the unit will be stored for more than one month. Leaky battery can badly damage the clock radio. Power Failure Indicator When AC power is interrupted (disconnected) for a short period of time, both time and alarm settings will change (unless optional battery is installed). After AC power is restored (reconnected), the Digital Display will blink to indicate that power was interrupted and you should readjust the time and alarm settings. 2 General Controls Front View VOLUME - / + - Adjusts volume level. WAKE UP - Selects Wake to CD mode track number and saves selected radio station as wake up station. DUAL ALARM EN CD TRACK WAKE UP SKIP FORWARD - In CD mode, skips to the next track. SKIP BACKWARD - In CD mode, skips to the previous track. OFF - Turns power off. MEMO RECALL - In radio mode, access memory location. MEMO SET - In radio mode, stores preset memory. SNOOZE - Enters snooze mode where the alarm will quiet but will sound again once the snooze period is over. PLAY/PAUSE - Starts and pauses CD playback. - Selects among playback options: repeat current track, repeat all, random playback, repeat all with random playback. 3 General Controls EN Top View Note: WAKE 1 CANCEL WAKE 2 << REV SET CLOCK/WAKE >> FWD NAP SLEE P OPEN CLOSE Speakers will still sound when any wake mode is activated even if headphone is plugged in. WAKE 1 - Activates Wake 1 settings and change wake 1 mode. WAKE 2 - Activates Wake 2 settings and change wake 2 mode. << REV - In clock and wake setting mode, counts backwards for clock time. In radio mode, tunes down radio frequency. FWD >> - In clock and wake setting mode, moves forward for clock time. In radio mode, tunes up radio frequency. SET CLOCK/ WAKE - Enters clock and wake setting mode. Headphones - Insert headphones here. Back View RADIO FM MONO / STEREO - In radio mode, selects between mono and stereo sound. MULTICOLOR - Selects among display colours. BRIGHTNESS LO / HI - Adjusts display light brightness. 4 General Controls Display WAKE 1 WAKE 2 1 2 1 2 1 2 STEREO CD TRACK MEMO MW FM MHz kHz Clock Display - In clock setting mode. 2 - Wake 2 to CD. WAKE 1 STEREO - In FM stereo mode. [. . . ] Note: · The next time you reactivate the sleep function by pressing SLEEP, SLEEP settings will remain the same as the last time they were set. · If you decide to turn off the unit sooner, press SNOOZE or OFF and this will shut off the sleep cycle. · When sleep mode is active, subsequent press on SLEEP to show the remaining time before the unit goes off. 14 Care and Maintenance Handling Compact Discs · Do not touch the signal surfaces. Hold by the edges, or by one edge and the hole. [. . . ]