User manual THOMSON RR95

[. . . ] To cut the power supply off, the power cable must be unplugged. RR95 EN 1 3/20/03, 2:17 PM TECHNICAL SPECIFICATIONS: Power supply AC 230V ~50Hz Clock backup:9V 6F22 Power consumption: 7W EN Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling. Do not place the system near wet areas such as bathrooms and pool side. Do not expose this appliance to rain or moisture Avoid storing the system at humid places or near abnormally heated areas. Power is continuously supplied to the system. [. . . ] Leaky batteries may badly damage the clock radio. 2 RR95 EN 3 3/20/03, 2:18 PM Operating the clock EN Memory Set Recall 1 BA ND c AL an C SET P NA NE TU IME T M AR el R ew IO RAD OFF ON Fw 2 d ALAR M SLEEP Setting Clock Time Your digital clock operates on a 24-hour standard mechanism. Press the SET button until a clock icon is shown on display. When you press and hold REV or FWD, the time decrements or increments will follow by a faster rate. No adjustment can be made when LOCK mode is selected. A Setting the Wake Time 1. Press the SET button once to set ALARM 1 (1 will flash on display), twice to set ALARM 2 (2 will flash on display). You can exit set mode by pressing SET button until no flashing sign or clock icon is displayed. Example 1: ALARM 1 mode setting: 8:50 AM Wake to Alarm Example 2: ALARM 2 mode setting: Alarm off 3 RR95 EN 4 3/20/03, 2:18 PM Operating the Clock EN Waking by Selected Source Programme You may be woken up by music or alarm . (refer to "Tuning the Stations") 2. Press the ALARM 1 or ALARM 2 button to select waking up by music or alarm. An indicator is up next to the selected setting. Note: When you turn off the alarm the music or usual. The radio will turn off when the preset time elapses. If you decide to turn off the radio sooner, press SNOOZE or OFF. When SLEEP is activated again, the sleep time will be the same as the one you set before. Press SLEEP to read the remaining sleep time. Nap Mode This function wakes you up after a short period of time. When the indicator is flashing, press REV or FWD to adjust nap time. The time range is from 10 minutes to 2 hours. The clock will be shown after 5 seconds if no button is pressed. Press NAP once to show time left. by pressing O F F the F, alarm or the music will turn on at the same time tomorrow. Note: The unit equips with GRAD-UWAKE feature, the alarm tone volume will increase gradually to its maximum in about 30 to 45 seconds. Sleep Mode In sleep mode, the radio will turn off automatically. Press SLEEP then the time display will exhibit 0:59 and the radio will turn on. While holding SLEEP, press REV or FWD to set the sleep time. The time range is from 1 minutes to 2 hours. [. . . ] The ALARM 1 and ALARM 2 indicator will be flashing. Press ALARM 1 or ALARM 2 button within 3 seconds to deactivate the alarm function permanently, "OFF" will be shown when the above procedures are done. Tip: You can activate the previously set alarm time by pressing ALARM 1 or ALARM 2 button. Brightness control You can adjust the backlight by the BRIGHTNESS button, there are three modes you may select from: OFF - Backlight always off. LOW - Backlight always low. Snooze Alarm Operation This operation allows extra sleep time after the alarm is on. [. . . ]