User manual THOMSON SPEEDTOUCH 330

[. . . ] SpeedTouchTM USB/330 ADSL USB Modem Installation and User's Guide 300 SERIES SpeedTouchTM USB/330 Installation and User's Guide RFC1483 Bridged 3EC 36716 BAAA TCZZA Ed. 01 Status Change Note Short Title Copyright Released PeckelbeenS CD-UG STUSB/330 R2. 0 RFC en © 2002 THOMSON multimedia. Passing on, and copying of this document, use and communication of its contents is not permitted without written authorization from THOMSON multimedia. The content of this document is furnished for informational use only, may be subject to change without notice, and should not be construed as a commitment by THOMSON multimedia. [. . . ] Note: In case the SpeedTouch Setup wizard (application) does not start automatically, open a 'Run' window via Start > Run from the Start menu and enter following path: D:\Setup. exe, where D stands for the drive letter of your CD-rom drive. The STUSB Setup program prepares the SpeedTouch Setup wizard (application): 2 As soon as the preparation is finished, the SpeedTouch Setup wizard (application) will start automatically. 3 The 'Welcome to SpeedTouchTM setup' window pops up: Click Next to proceed. 3EC 36716 BAAA TCZZA Ed. 01 11 3 SpeedTouchTM for Microsoft Windows Step 4 Action The 'Software License Agreement for SpeedTouchTM' window pops up: Click Yes to accept the terms of the agreement and to continue the installation. Note: ADSL must be available, as well as the appropriate central splitter or distributed filters. Windows will automatically recognize the STUSB. The Windows 'Found new Hardware' wizard pops up. This wizard will guide you through the installation procedure. In most cases you only have to click Next to proceed with the installation procedure. At some point the STUSB Installation CD-Rom will be requested. At this point the SpeedTouch Setup wizard (application) will continue with the installation of the STUSB software and applications. The installation finishes with setting up STUSB's ADSL Wide Area Network (WAN) connectivity. The installation of the STUSB is now finished. The STUSB is now prepared for connecting you to the Internet. Using the SpeedTouchTM" on page 16). 2 3 4 Installation results After you have correctly followed the STUSB installation procedures, the following folders and icons are added to your system: · · · SpeedTouch USB program folder: The SpeedTouch USB Diagnostics application is added. Desktop SpeedTouch Dial-up icon: A SpeedTouch Dial-up icon is added to your desktop. System tray SpeedTouch status icon: An STUSB status icon is added to the system tray, allowing instant status information of the STUSB. 3EC 36716 BAAA TCZZA Ed. 01 15 3 SpeedTouchTM for Microsoft Windows 3. 2. Using the SpeedTouchTM STUSB status icon As soon your STUSB is installed, a STUSB status icon is shown at your desktop's system tray. The STUSB status icon is colored, depending on the state of the STUSB device. If you position your mouse pointer over the STUSB status icon, a message pops up: System tray icon Message ADSL Modem Modem not plugged in Description The STUSB is not plugged into the PC's USB port. An ADSL connection can not be established. [. . . ] If reinstallation has not resolved the problem, contact the company from which you purchased the STUSB for assistance. STUSB LEDs Your STUSB is equipped with two Bi-colored LEDs . These indicators indicate the status of the STUSB. Checking the STUSB status may be a first step in isolating the problem. [. . . ]