User manual THOMSON TDW4760BK

[. . . ] Other residential type This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been Be play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. For the details concerning the method and frequency of cleaning, please see section "Cleaning and maintenance" on pages 20 &21. [. . . ] Left and right parts of rack are tilted. Move the right part over the left part. Fill the salt container before starting the washing programme. In this way, the excess Saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion. If you plan to use dishwasher tablets for your washing needs, then you do not require to Use salt or rinse agent but please note that the refill salt indicator light will remain illuminated on the control panel. This is quite normal and will not affect the operation of your dishwasher. After the dishwasher is switched on, enter the status of adjusting the salt consumption Until the value " H3 " (factory setting) shows on the display. While the value is shown, repeatedly press suit the water hardness. To adjust the setting from H1 to H6 to Unscrew the cap from the salt container by turning it anticlockwise. Place the supplied funnel so the end fits into the opening of the salt container. NOTE: The salt container must only be refilled when the refill salt indicator light illuminates. Depending on how fully the salt dissolves, the refill salt indicator light may still be on even though the salt container is filled. using the Rinse Aid and Detergent Dispensers The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining. It is automatically added to the water during the final rinse cycle. The detergent and rinse aid dispensers are located on the inner part of the door: the detergent dispenser is on the right, and the rinse aid dispenser is on the left. Add the rinse aid until the container is full. The optical level indicator on the side of the cap should be completely dark. NOTE: Refill the rinse aid when the optical level indicator becomes clear again, or when the rinse aid warning light illuminates. The factory setting for the dishwasher is 3 and you can choose among 6 settings. The amount of rinse aid dispensed is proportional to the selector position. To adjust the rinse aid setting, remove the dispenser cap. Use a screwdriver (not supplied) to rotate the rinse aid Replace the cap and turn it clockwise. [. . . ] Lift up the filter unit and then separate the filters. Rinse them under running water using a soft brush. Replace the filter unit by turning them clockwise until they lock into position. CAUTION: Never operate the dishwasher without the filters. [. . . ]