User manual THOMSON TM9245

[. . . ] Safety Information EN For UK Only CONNECT THE MAIN LEAD INTO A MAINS POWER SOCKET POWER SUPPLY 230V. Note: The mains lead of the set is fitted with a moulded plug. If the mains socket are not compatible or if for any reason the plug is removed please follow the directions below. The moulded plug cannot be rewired and if removed must be disposed of safely. [. . . ] If moisture forms inside this system, it may not operate properly. To correct the problem, turn off the power and wait about 30 minutes for moisture to evaporate. · This system is fitted with a laser. To avoid accidents, it is to be opened by qualified technicians only. · Never leave the tray open as dust could cover the laser lens and/or the tray could be bumped into accidentally. · Do not place the system near wet areas such as bathrooms and pool side. Avoid storing the system at humid places or near abnormally heated areas. · Power is continuously supplied to the system. To disconnect power completely, unplug the power cord from the power outlet. · Ensure minimum distance around the apparatus for sufficient ventilation. The ventilation should not be impeded by covering the ventilation openings with items, such as newspaper, etc. · No naked flame source, such as lighted candles, should be placed on the apparatus. · Attention should be paid to enviornment aspects of battery disposal. AC Power Plug the power supply cord into the AC power jack on the back of the unit, and into an AC power supply outlet that accepts the plug supplied with your unit. 2 Before You Begin Battery Power You can insert 6 D-sized alkaline batteries (not supplied) and you can take your stereo just about anywhere. · Open the battery compartment door on the bottom of the unit by pressing down on the tab and pulling out the cover. · Before inserting the batteries, observe the polarities (that is, + and -) of the battery, then relate the polarities to the engraved diagram located on the battery compartment door. Insert batteries in the battery compartment. 3AA-sized batteries (not supplied) are needed to keep radio station memory. Note that the AC line cord must be unplugged from the jack on the back of the unit to operate on batteries. · Any battery may leak electrolyte under the following circumstances: - if mixed with a different battery type, - if inserted incorrectly, - if all batteries are not replaced at the same time, - if disposed of in fire, or - if an attempt is made to charge a battery not intended to be recharged EN Attention: Be sure to remove batteries when storing the set for more than 30 days. Leaky batteries can badly damage the system. Be sure to dispose of leaky, weak or dead batteries properly according to federal, state, and local regulations. To prevent injury or damage, do not reverse batteries and do not mix battery type. Important Battery Information · Remove the batteries to avoid leakage if you do not use your system for more than one month. · Discard leaky batteries immediately as leaking batteries may cause skin burns or other personal injuries. EQ - Selects among EQ options (FLAT, CLASSIC, ROCK, POP) BASS BOOST - Turns digital bass boost system on and off. [. . . ] Press FOLDER the folder and press PROG. . Displaying Program List Press PROG. repeatedly to recall and display program. Deleting the Program Press STOP in CD stop mode to delete all the stored tracks. Tips: Opening the CD compartment door or switching mode will delete all the stored tracks. 11 AUX EN L IN R Connect one end of the RCA cable (not included) to the AUX IN L / R connector on the main unit and the other end to the AUX Out connector on an external source. Make sure the colours of the cables match the connectors. Select AUX mode by pressing RADIO / CD / AUX. 12 Troubleshooting Tips Problem System doesn't turn on No sound Solution · Unplug the unit for a moment, and then plug it back in. [. . . ]