User manual THOMSON TX807C

[. . . ] tx807en2 15/01/03 12:26 Page 1 About this manual This manual is common to several TV models. Therefore, the model you bought may not support some of the functions or settings described hereinafter. The mains plug must be easily accessible. In the following cases, we recommend that you pull out the mains connector: 1. In such a case, it is advisable that you also disconnect the TV set from the aerial socket. [. . . ] Once your channels are duly sorted, close the menu through exit. You may recall this menu by pressing the menu key: - 4 times for the mono TV sets - 5 times for the stereo TV sets. Note: For channels diffusing teletext in Czech, Slovak, Rumanian, Croat, Russian or Greek. After having tuned in the channel, display the manual channel set-up menu (see page 6). - Select the Text line by pressing 5 times on the Down button of the remote control. - Select the number of the character table, using the table on page 7. - Memorise it with OK and then quit the menu with Exit. Automatic Channel Set-up With the Automatic Channel Set-up ¥ When a VCR or satellite receiver is connected to the aerial socket, you must switch on this equipment. Should external equipment be connected to the TV set via the SCART socket, it must be turned off. The first time you switch your TV set on, the automatic installation (AUTO INSTALL. ) will automatically appear. If it does not, you will find this menu by pressing a number of times on the remote control menu key: - 3 times for the mono TV sets - 4 times for the stereo TV sets. ¥ Depending on the model of your TV set, youÕll have to select from the options listed below the one that fits with your country: EURO : Western Europe, Tunisia, Morocco FR : France, Luxembourg UK : United Kingdom, Eire DK : Eastern Europe, Middle East, Africa, French DOM-TOM Select corresponding option by means of the directional keys Left/Right. This line allows you to select a set-up to be carried out either through channels (CH/CC) or through frequencies (MHz). ¥ Select the type of wished-for set-up through the directional Left/Right keys. 4 tx807en2 15/01/03 12:26 Page 5 Manual Channel Set-up With the manual set-up 1. Display the menu by pressing a number of times on the remote control menu key: - twice for the mono TV sets. Depending on the model of your TV set, youÕll have to select from the options listed below the one that fits with your country: EURO : Western Europe, Tunisia, Morocco FR : France, Luxembourg UK : United Kingdom, Eire DK : Eastern Europe, Middle East, Africa, French DOM-TOM Select corresponding option by means of the directional keys Left/Right. 2 . Select the Mode line through the Up/Down directional keys. By means of the Left/Right directional keys, select ANTENNA (reception through an aerial antenna) or CABLE (reception through a cable network) for a Channel set-up, or MHz for a Frequency set-up. Select the CH or CC line through the Up/Down directional keys. Start the set-up in a decreasing or increasing order by means of the Left/Right directional keys. When a channel is found, the pictures appear. If the picture quality is poor, make use of the directional keys Up/Down to select the line ->. <- and try to improve picture quality with the directional keys Left/Right. line through the Up/Down directional keys 7. If the station is encrypted and if you want to connect a decoder to the AV socket, tick the box with the Left/Right keys. [. . . ] Once you have found the page, the subtitle and/or news will be superposed on the TV picture. Choice of the character set table If the characters on the teletext page are inaccurate, verify that you have chosen the correct character table as indicated on pages 6 and 7. If you have chosen the correct table and a few characters are nevertheless inaccurate, proceed as indicated below. Press the Text button for at least 3 seconds and then release it to go from the default character table to the alternative table and vice-versa. [. . . ]