User manual THOMSON WHP 265

[. . . ] Follow the instructions carefully and carry them out in their correct order. keep these instructions for later reference. This devices is delivered with batteries. Before charging, study the instructions of this manual. [. . . ] If for exceptional reasons you must utilise it out of doors (balcony, veranda, etc. ) take care to protect it from dampness (dew, rain, splashes). the maximum ambient humidity that the device supports is 85%. If your unit is cold and you wish to use it in a warm room, wait until any condensation on the unit evaporates by itself before you switch it on. You must only clean your unit using a soft cloth soaked in a neutral detergent. You may damage your unit if you use solvent or an alcohol-based product. THOMSON declines all liability for any use that does not comply with this instruction notice. Its range of operation corresponds to the typical use of such products. See illustration (B) inside for its range of operation and then follow the instructions in this leaflet. see also the connection diagram on page 2. Your headset is fully autonomous thanks to two AAA batteries that you need to install in each earpiece of the headset. The foam rubber of each earpiece slides out to allow you to do this. ) taking care to aim the LED diodes in the direction of the area where you will be listening and taking care that there are no intervening obstacles (objects, people, animals, etc. 3 Plug the AC-DC (3) plug into the DC IN of the transmitter (1) then plug the adaptor into a 230 V, 50 Hz mains socket. 1 Slide out the rubber foam from each earpiece sufficiently to install two AAA batteries, taking care to place them pointing in the correct direction, so that the polarity is respected. Take care in fitting it (there are 2 hooks and 2 lugs). Do not force it, sliding into place is possible without forcing. OUT (4) cable from the transmitter (1) into the headseat (10) and place the ON/OFF button on the headset (8) to OFF. The rechargeable batteries must be fully charged for 20 at 24 hours before use. While the unit is being charged, the red indicator light is lit (11). [. . . ] 1 Turn on the equipment that you wish to listen to and adjust its volume level accordingly. For correct operation ensure that the sound level of the source (headset plug) is sufficient. For example adjust it to half its full volume level. With some equipment you may need to adjust the volume on the headset plug via the configuration menu. [. . . ]