User manual THUNDER TIGER EK4-S2

[. . . ] 1/8 OFF-ROAD, 4WD MONSTER TRUCK No. 6216 JD1440. V3 Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship. The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty does not cover any components damaged by use or modification. Part or parts missing from this kit must be reported within 60 days of purchase. [. . . ] Please e. Remove the outer foam from filter and make it moist evenly with a few drops of fuel. If the vehicle will be operated in an area with fine dust, use filter oil or caster oil instead of fuel and make both the inner and outer foam moist. It is important that the foam is only moist to trap dirt and allow air passage. With the foam too wet, limited air can pass through; therefore, limiting engine performance. Install the filter boot onto the engine carburetor and make sure the air cleaner boot is securely fastened with a zip-tie. f. 6 13 a a. c. FUELLING b c Remove the cap from fuel bottle nozzle. Squeeze the fuel bottle, insert into fuel, and draw fuel into the fuel bottle. Fill car's fuel tank with glow fuel. FUEL RECOMMENDATION A good quality, commercially available model engine fuel containing 5% to 30% nitro with 15% to 25% oil is recommended for initial break-in and regular run-in of this engine. Thunder Tiger also recommends that the oil composition to be made of caster oil or a caster/synthetic blend. Fuel containing only synthetic lubricant is much less tolerant of high temperature and lean carburetor settings; thus, may cause the engine to become difficult to operate under normal conditions. Less % of nitro in fuel means that the engine will produce slightly less power. Conversely, fuel with less nitro % will have higher alcohol % which enables the engine to operate at a much lower temperature. Thunder Tiger finds that the PRO-70BX performs best (power vs. Oil composition in fuel is vital for a 2-cycle engine's moving internal parts. More % of lubricant means that the fuel has more oil to lubricate the moving parts. This is especially important for ring engines such as the PRO-70BX. Thunder Tiger finds that the PRO-70BX performs best with 20% oil. GLOW PLUG RECOMMENDATION The length of the glow plug and the quality of its coil have a major impact on overall performance and reliability of the engine. The engine operates best with a platinum coil plug rated at medium to hot temperature. The following is a list of glow plugs suitable for use in this engine: Thunder Tiger 9281, Enya #3/#5, McCoy #9/#59, Novarossi C4S/C5S/C6S, OS A3/A5/#8, and Picco P6S/P7S. WARNING Thank you for purchasing a Thunder Tiger Product. Please read all instructions thoroughly before operation. It is important to familiarize yourself with the model, its manual, and its construction before assembly or operation. Do not operate model products in rain, on public roads, near crowds, near airport, or near areas with restricted radio operation. [. . . ] Follow the procedure for starting the engine. To set the idle, turn the idle screw clockwise (higher RPM) or counterclockwise (lower RPM). Basically, the idle needs to be set at the lowest possible RPM before the engine stalls. With a running engine, run the car back and forth in a straight line (full throttle achieved during each passage) in an open parking lot. [. . . ]