User manual THUNDER TIGER MN-24 ASSEMBLY

[. . . ] Please read all instructions and familiarize yourself with the systems and controls of this product before operating. You should enjoy many hours of trouble free use from this advanced R/C product. We offer online help 24-7 on our www. acehobby. com forum and our product specialists are ready to take your call if you have any technical questions. Have fun and enjoy the exciting world of R/C. CAUTION Thank you for purchasing a Thunder Tiger Product. [. . . ] On a stick transmitter, the trim levers are located accordingly around the sticks. For more details, please check the transmitter instruction manual. 7 OPERATING RADIO STEERING FUNCTION a b c a. Check the radio steering functions. With the radio transmitter and receiver on, turn the steering wheel / stick to the left. The front tires/wheels should turn left accordingly. If not, flip the steering servo reverse switch. Return the steering wheel / stick to neutral. The front tires/wheels should point straight forward. If not, use the steering trim lever to correct it. Turn the steering wheel / stick to the right. The front tires/wheels should turn right accordingly. 8 OPERATING RADIO THROTTLE / BRAKE FUNCTION a b c a. Check the radio throttle/brake functions. With the radio transmitter and receiver on, pull the trigger / push the stick forward. Now turn the low-speed mixture screw counter-clock 6 1/2 turns. Remove the outer foam from filter and make it moist evenly with a few drops of fuel. Put the filter in a plastic bag and knead it until the foam is saturated, but not soaked. Finally, make sure the air cleaner boot is securely fastened with a zip-tie. Never run your vehicle without the air filter . If the vehicle will be operated in an area with fine dust, use filter oil or caster oil instead of fuel. It is important that the foam is only moist to trap dirt and allow air passage. With the foam too wet, limited air can pass through; therefore, limiting engine performance. 11 FUELLING a b c a. Squeeze the fuel bottle, insert into fuel, and draw fuel into the fuel bottle. Fill car's fuel tank with glow fuel. The fuel used should be methanol based model engine glow fuel (available at hobby shops) with 10% to 30% nitro content and 5% to 18% caster/synthetic oil content for lubrication. 12 PREPARING THE ENGINE FOR STARTING a b c d e f a. To start an engine, first remove the glow plug with the included wrench. Check the glow plug by plugging it into the glow plug igniter. [. . . ] Re-adjust carburetor, see "Fuel Mixture" or "Factory Carburetor Settings" section below. Exhaust blocked . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Air cleaner blocked . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Adjust idle speed screw, see "Fuel Mixture" section below. [. . . ]