User manual THUNDER TIGER RAPTOR V.2

[. . . ] For sport kit (29BB) version, (3) will be replaced by Bushing(BK0107x4) Warning, do not over-torque the self-tapping screws. After Flight Checklist (1) Check every screw and bolt to make sure none has loosened due to vibration. (2) Check every rotating and movable part to ensure they still move smoothly and normally. [. . . ] The throttle stick should never exceed the 1/3 positiom when starting the engine. (2) Try a new or different type of glow plug. There are different types of glow plugs on the market for different types of fuel and operating conditions. Seek the advice of experienced fliers and also experiment with different types of glow plugs until you find the one that suits your operating condition the best. *Engine runs, but the helicopter will not lift off. (1) Check the main rotor blade pitch angle, they should be set at 5. 5 to 6 degrees when the transmitter throttle/collective stick is at the center position. (2) Does the engine throttle arm move properly?The carburetor opening should be fully open when the transmitter throttle/collective stick is moved up. The carburetor opening should be nearly closed when the transmitter throttle/collective stick is moved down. And the opening should be completely closed when the transmitter throttle/collective stick is moved down and the throttle trim is also moved down. (3) Check your engine manual for proper starting point settings. If smoke is excessive when adding throttle your high speed needle may be too rich. [. . . ] 31 SPECIFICATION: Full length of fuselage:1150mm(45. 27") Full width of fuselage:140mm(5. 51") Total height:400mm(15. 75") Main rotor dia:1245mm(49") Tail rotor dia:260mm(10. 25") Gear ratio:1:9. 56:4. 57 Full Equipped weight:3000g (6. 6 lbs) THUNDER TIGER CORP. www. thundertiger. com C 2004 JK0094. V3 Printed in Taiwan [. . . ]