User manual THUNDER TIGER RIPPER SENSORLESS BRUSHLESS MOTOR INSTRUCTIONS

[. . . ] No part or parts will be sent under warranty without proof of purchase. To receive part or parts under warranty, the service center must receive a proof of purchase and/or the defective part or parts. Should you find a defective or missing part, contact the authorized Thunder Tiger Service/Distributor nearest you. Under no circumstances can a dealer or distributor accept return of a kit if assembly has started. 1a d INSTALLING THE RADIO GEAR b c e f g h i a. [. . . ] Then, manually close the carburetor, and set the collar (next to the spring) with the spring slightly compressed. Then, set the other collar next to the linkage pivot. 12 a d ADJUSTING CARBURETOR b c e f a. To set the carburetor idle (small screw with spring off center on the side of carburetor body), turn the screw as pictured. Please refer to ENGINE BREAK-IN/TUNING procedures to properly set the engine. b. To set the high speed needle (large needle sticking out from the carburetor body), turn the screw as pictured. Please refer to ENGINE BREAK-IN/TUNING procedures to properly set the engine. c. To set the mid speed needle (large needle in the middle of the carburetor body), turn the screw as pictured. Please refer to ENGINE BREAK-IN/TUNING procedures to properly set the engine. d. To set the low speed needle (large needle in the throttle lever), turn the screw as refer to ENGINE BREAK-IN/TUNING procedures to properly set the engine. pictured. Please e. Remove the outer foam from filter and make it moist evenly with a few drops of fuel. If the vehicle will be operated in an area with fine dust, use filter oil or caster oil instead of fuel and make both the inner and outer foam moist. Keep the fuel bottle cap tightly closed. Clean up any leak or excess fuel before starting the engine. This product, its parts, and its construction tools can be harmful to your health. Always exercise extreme caution when assembling and/or operating this product. Do not touch any part of model which rotates. Check your radio frequency with the proper operating frequency of the area or country. Always check to see if there are any modelers operating on the same frequency as your are. Also, check your radio for proper operation before operating a mode. Improper operations may cause personal and/or property damage. Thunder Tiger and its distributor have no control over damage resulting from shipping, improper construction, or improper usage. Thunder Tiger assumes and accepts no responsibility for personal and/or property damages resulting from the use of improper building materials, equipment and operations. [. . . ] Set the idle screw (small screw with spring off center on the side of carburetor body) so that the carburetor has 2mm opening when the throttle is closed. 9 2. Check the carburetor's mid speed needle / spray bar. Set the mid speed needle / spray bar (small screw in the center and on the side of carburetor body) so that its outer most edge sits flush with the carburetor body side. Only make engine tuning adjustments with idle screw, high speed, and low speed needles. [. . . ]