User manual THUNDER TIGER TOMAHAWK ST

[. . . ] 34 Air extraction 2 IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. [. . . ] Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last movement of the joystick. ^ Press the joystick once to the right to turn the fan back on again. 12 Operation Filter timers Grease filter timer A timer monitors the hours of operation. The indicator for the grease filter will light after 30 hours of fan operation. The grease filters must then be cleaned. After the grease filter has been cleaned and put back in place, the grease filter timer must be reset. Checking the filter timers To check the percentage of time set already used: ^ Press the joystick to the left to turn the fan on. ^ To do this press the grease filter button for about 3 seconds. To change the hours of operation, see "Reprogramming the timers". Charcoal filters The timer for the charcoal filter is not preset. Please program this timer, see "Operation / Reprogramming the charcoal filter timer". The charcoal filter indicator will light once the selected time has elapsed. Press it to the left for a shorter operating time, to the right for a longer operating time. ^ Press the Delayed Shut Down and charcoal filter buttons at the same time. The indicator for the charcoal filter and one of the fan power scale indicators will flash. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ After returning the grease filters, press the grease filter button for 3 seconds to reset the timer. ^ If the grease filters are cleaned before the grease filter timer has reached its maximum, the grease filter button should be pressed for 6 seconds to reset the counter to zero 18 Cleaning and care Active charcoal filters In recirculation mode four active charcoal filters must be used in addition to the grease filters. The charcoal filters are designed to absorb cooking odors. They are located in the canopy above the grease filters. Active charcoal filters can be ordered from Technical Service. USA 1-800-999-1360 CDN 1-800-565-6435 Please quote part # 03 174 713 ^ The grease filters must be removed to acces the active charcoal filters (see "Cleaning and Care / Grease filters"). Before using: ^ Program the charcoal filter timer, see "Operation/Reprogramming the charcoal filter timer". Replace the active charcoal filters when the charcoal filter indicator lights. These filters should be replaced at least every 6 months or when they no longer absorb odors efficiently. ^ After replacing the charcoal filters, press and hold the charcoal filter button for 3 seconds to reset the timer. ^ If the charcoal filters are replaced before the timer has reached its maximum, the charcoal filter button should be pressed for 6 seconds to reset the counter to zero. ^ Insert the charcoal filters and fasten with the enclosed screws. ^ Return the grease filters. 19 Cleaning and care Changing the light bulb Before changing the light bulb, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. [. . . ] ^ Place a spring washer between the joystick base and the extension. Tighten the extension by hand while countering the joystick base with a wrench. ^ Insert the lower half of the desired joystick into the socket, loosely secure it in place with the included screw and spring washer. Make sure the respective screw for the desired joystick is used. ^ Turn the printed part of the joystick so that the m-symbol faces front. [. . . ]