User manual THUNDER TIGER TS-4E SPORT V.2

[. . . ] Use the appliance only for its intended purpose. , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Use this appliance only in the manner intended by the manufacturer. appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. properly installed and grounded by a qualified technician. [. . . ] Before using the hood in recirculation mode, ensure that the active charcoal filters are in place, see "Cleaning and Care". 7 Guide to the Ventilation System 8 Guide to the Ventilation System a Chimney extension b Chimney c Canopy d Grease filters e Charcoal filter optional accessory f Recirculation vent g Control panel h Overhead lighting i On/Off button j Power level buttons Four fan speed selection k On / Off button for the lighting 9 Operation Turning on the fan s ^ Press the On/Off button s. The fan turns on to Level "II". Automatically switching back the intensive power level The intensive level can be programmed to automatically switch back to level 3 after 10 minutes. ^ Turn the fan and the overhead lighting off. ^ Press and hold the - and + buttons for approx. 10 seconds until power level indicator 1 lights up. ^ Then press the following buttons one after another : ­ light I, ­ the "­" button, and ­ the light button I again. If the indicators 1 and 4 flash, the automatic switch back is not activated. ^ To activate the automatic switch back, press the "+" button. The power level indicators 1 and 4 light continuously. To deactivate, press the "­" button. Used charcoal filters may be discarded in household trash. 14 Cleaning and Care Changing the light bulbs , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before changing the light bulbs, disconnect the hood from the power supply, see "Important Safety Instructions". When in use halogen bulbs become extremely hot, and can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool. ^ To change the halogen bulb, first gently press the light cover. The cover will open and can now be flipped down. ^ Pull the halogen bulb from its socket. ^ Using a cloth or glove, insert the new halogen bulb (type 12 V, 20 W, G4). Please follow the manufacturer's instructions. ^ Flip the light cover back up, making sure it clicks into place. 15 After Sales Service Repairs In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department. ^ When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filters are removed. MieleCare (USA only) MieleCare, our Extended Service Contract program, gives you the assurance of knowing that your appliance investment is covered by 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. [. . . ] ^ Verify that the voltage, load and circuit rating information found on the data plate (located behind the grease filter), match the household electrical supply before installing the hood. If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele's Technical Service Department. Important To increase security before the machine is installed, it is recommended to install a protective switch (30 mA). Important The hood must be hard wired accordingly: Black/Red wire:. [. . . ]