User manual THUNDER TIGER TS-4N PRO V.2

[. . . ] 1/10 NITRO POWERED 4WD TOURING CAR No. 6167-F JD6221 Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship. The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty does not cover any components damaged by use or modification. Part or parts missing from this kit must be reported within 60 days of purchase. [. . . ] The front tires/wheels should turn right accordingly. 9a a. c. OPERATING RADIO THROTTLE / BRAKE FUNCTION b c Check the radio throttle/brake functions. With the radio transmitter and receiver on, pull the trigger/push the stick forward. The carburetor should be fully opened and the brake disengaged. To reverse this function, flip the throttle/brake servo reverse switch. The carburetor should be closed to a point where the idle has been set (see step for ADJUSTING THROTTLE/BRAKE LINKAGE), and the brake still disengaged. If not, use the throttle/brake trim lever to correct it. Push the trigger/pull the stick backward. The carburetor opening should still be the same at neutral, throttle spring compressed slightly, and the brake engaged. 5 10 a a. c. ADJUSTING THROTTLE / BRAKE LINKAGE b c To set the throttle/brake linkage, first the radio should be on and neutral; thus, the servo is at neutral position. With the servo at neutral, turn and adjust the brake adjust knob to a point where the brake lever almost engages the brake system, but not yet. With the servo at neutral, loosen the throttle collars. Then, manually close the carburetor, and set the collar (next to the spring) with the spring slightly compressed. Then, set the other collar next to the linkage pivot. 11 a a. b. ADJUSTING CARBURETOR b c To set the carburetor idle (small needle sticking out from the carburetor body), turn the screw as pictured. Initial idle setting should leave 1mm carburetor gap. Clockwise turn will provide higher idle (larger carburetor opening), and counterclockwise turn will provide lower idle (smaller carburetor opening). To set the high speed needle (large needle sticking out from the carburetor body), turn the screw as pictured. Initial high speed needle setting should be 2. 5 turns (close the needle completely, then back out 2. 5 turns). Clockwise turn will provide leaner setting (lower fuel to air mixture), and counterclockwise turn will provide richer setting (higher fuel to air mixture). Please refer to ENGINE BREAK-IN/SETTING procedures to properly set the engine. Remove the outer foam from filter and make it moist evenly with a few drops of fuel. [. . . ] Please read all instructions thoroughly before operation. It is important to familiarize yourself with the model, its manual, and its construction before assembly or operation. Do not operate model products in rain, on public roads, near crowds, near airport, or near areas with restricted radio operation. Always keep fuel away from heat and open flame. [. . . ]