User manual TIMEX TE103 TIMER

[. . . ] 2f After the hour is set, press "SET' key to confirm the hour. The hour will stop flashing and the minute will start to flash. 2g Press">' or '<-' key to set the current minute. 2h After the current time is set, press "SET" key to confirm the current time you have adjusted. [. . . ] The timer will be in AUTO OFF status until the next ON starting command. If the present timer status is AUTO OFF and you would like to change it to AUTO ON, just press the OVER" button to change the status to AUTO ON. The tinner will be in AUTO ON status until the next OFF starting command. The LCD displays the output status at all times as shown below AUTO OFF: The timer is currently in OFF status and will be switched on under control of the programme. AUTO ON : The timer is currently in ON status and will be switched off under control of the programme. ON : The unit is in permanent ON status, regardless of programme. OFF : The unit is in permanent OFF status, regardless of programme. Indicator Light There is a red indicator light on the left side of the top next to the TIME button. The indicator lights up whenever the timer output is switched ON. Program Reset (RST button) Pressing the "RST" button will clear all preset programs and the current time setting. B&Q plc. Visit us at www. diy. com Tools Required (not supplied) :A pointed tool (e. g. a pen) is required for operating the RST and RND buttons. Setting the timer 1. Initial Operation 1. 1 Plug in the timer for approximately 6 minutes to charge rechargeable battery. Note: The timer contains a non-replaceable rechargeable battery. The battery is used to power the timer memory whilst the timer is unplugged (or if mains power is interrupted) If the timer is left unplugged for some time, the battery will run down and the current time and all programmes will be lost. If this occurs, plug in the timer to recharge the battery, The timer will operate regardless of battery condition so long as it remains plugged in. a pencil) to press 'RST' (RESET) key to clear the memory. 180402 7. Countdown Setting (Up to 24 hours) The timer has a countdown function. 2 hours) to be entered, then when the countdown (CTD) button is pressed, the timer will switch on for the set period and then switch off. The countdown period can be set as follows: 6a Press "<--" key. The display "CTD" sign will come on and ON will flash. 6c Press"--·" or <-" key to set the countdown hours. [. . . ] The "+1h" sign will disappear. 10. 12 Hrs (AM/PM) and 24 Hr Clock display changeover Press and hold the "TIME" button for about three seconds. The time will change from AM/PM mode to 24 Hrs mode (or vice versa). Usage - Important 1 Do not exceed the current capacity of the timer. This timer is rated at 13 Amps (resistive loads) and 2 Amps (inductive loads) Typical resistive loads are: Lamps Radios Simple Heaters, Radiators etc. Inductive Loads include most motor-operated appliances, e. g. : Fan heaters Washing Machines Dishwashers Tumble Driers Therefore the timer should not be used with these products if they exceed 2 Amps (48C Watts ) 2. [. . . ]