User manual TISSOT AUTOMATIC CHRONOGRAPHS COSC

[. . . ] * Automatic Chronographs COSC User's Manual 5 1 6 11 8 7 3 10 4 2 9 Display and functions Hour hand Minute hand Small seconds hand Date display Chronograph : Central 60-seconds counter hand 30 minute counter hand 12 hour counter hand Tachometric scale (depending on models) Stop/Start push button Reset push button on counters Crown with 3 positions (11) : I Winding position (not pulled out) II Setting position for date (unscrewed*, half pulled out) III Setting position for time (unscrewed*, completely pulled out) * Models with a screwed crown : IA Initial position (screwed down, not pulled out) IB Winding position (unscrewed, not pulled out) w w w. ch 1/2 136_EN / 08. 06 Automatic Chronographs COSC * Congratulations We would like to congratulate you on having chosen a self-winding chronograph TISSOT ®, one of the most highly renowned Swiss brands in the world. [. . . ] Speedometer (depending on the model) The speedometer is used to measure the speed of an object which is moving at a constant speed. Start the timing operation and stop it again once you have covered a distance of 1 km. The chronograph hand then points at a numeral on the tachometric scale (8), indicating the speed in km/h. Care and maintenance We would advise you to clean your watch regularly (except for the leather strap) using a soft cloth and warm soapy water. After immersion in salty water, rinse it in fresh water and leave it to dry completely. Do not leave it anywhere where it might be subjected to major variations in temperature or humidity, in direct sunlight or near strong magnetic fields. To benefit from the highest standards of service and to ensure your guarantee remains in force, please always contact an approved TISSOT ® representative or retailer. The high-quality mechanism of your TISSOT ® watch will give you complete satisfaction for many years provided that you take proper care of it. However, we would advise you to have your watch inspected every 3 to 4 years by an approved TISSOT ® representative or retailer. Usage / Settings Models with a screwed crown To ensure that they remain water-resistant, some models are fitted with a screwed crown. Before proceeding to setting the time or date*, you must first unscrew the crown into position IB before pulling it out into position II or III. Important : After each operation, you must always screw the crown back down to ensure that your watch remains water-resistant. Winding Crown in position I/IB, not pulled out Manual winding is necessary if you have not been wearing your watch for some considerable period of time. To restart it, you only need to turn the crown a few times (clockwise), or to tilt your watch from side to side a few times. To restore the power reserve of your watch to 42 hours, you need to turn the crown about 32 times (clockwise). Whenever you wear your watch, the automatic mechanism is wound every time you move your wrist. [. . . ] During this operation, your watch will continue to function normally, so you will not need to alter the time. Note : When setting the time, if the chronometer is engaged, the hand on the 12 hour counter will turn together with the hour hand of the watch. w w w. [. . . ]