User manual TNB 2.1 CH. SPEAKER SYSTEM

[. . . ] It has been certified from WELS(Water Efficiency Labelling and Standards) of Australia. The Silver Wash System This is a wash control system that enables to kill bacteria hidden in the cloth during the wash or rinse, to protect human skin from harmful bacteria through the antibiotic coating by SILVER Wash, and to realize a pleasant, healthy sanitization. This system also prevents propagation of bacteria through antibiotic coating on the washed cloth. The Mist Shower Effective residue removal - The mist dissolves laundry detergents more effectively to leave behind less residue. A fine mist of water spray over the laundry reduces the amount of water necessary. Air Turbo technology spins hard and fast so you can spend less time drying. [. . . ] Soaking is automatically applied during a Clean tub course. You can set the soak time from between 10 to 60 minutes. The mist dissolves laundry detergents more effectively leaving behind less residue. Press this button to finish the wash at a specified time. Turn off your washing machine to cancel a reserved delay start. You can set the delay start time from between 3 to 18 hours. A course where silver water is supplied during the wash as well as during the last rinse, with sterilization and an antibacterial coating. - Sanitization: Silver water is added to the water supply to perform an antibiotic sanitary wash. Sanitization is an antibiotic sanitary course. If only a hot water is selected, Silver wash cannot be selected. - Bacteria protection: Silver water is supplied during the last rinse after the wash to apply an antibacterial coating to the laundry during the rinse. - When doing the laundry after cleaning the tub, you may find some impurities. These are just detergent residues and impurities after the tub cleaning. Perform the rinse cycle two to three times. - The Soak function (20 minutes) is set automatically. - The water level is set to Mid early on and then changed to High during the rinse. KEEPING THE TUB CLEAN When using the machine under humid conditions for an extended time, various bacteria from the air may stick to the tub and form black dirt (fungi), causing damage to the human body. To keep the tub clean and hygienic at all times, it is recommended reading "CLEAN TUB COURSE" above and using only dedicated or recommended detergents to clean the tub regularly at least once every one to three months. 12_Setting up your washer 2. 1 CH. SPEAKER SYSTEM-02444N_EN(ӽ). indd 12 2009-05-28 5:01:47 WATER SAVING COURSE This program reduces water consumption. Water saving, high water level, cold & hot water temperature is recommended for a normally soiled cotton load. Press the Power button to "On". Press the Course select button three times. If you want to pause, press the Start/Hold button again. [. . . ] CHECK & SOLUTION Is the electric voltage normal? Press the Start/Hold button one more time and check if the washer starts. Is enough water filled to the water level? If the water pressure is low, it takes a long time to start washing. [. . . ]