User manual TNB CSAFM10

[. . . ] gB Intended use This rainwater collector is intended for installation in a vertical downpipe. There it collects rainwater flowing from the roof water and directs it to a rainwater barrel. It can be used for roof areas of up to about 80 m² in size. This rainwater collector can be installed on standard rainwater downpipes made of metal or plastic with diameters from 70 - 110 mm. [. . . ] This rainwater collector can be installed on standard rainwater downpipes made of metal or plastic with diameters from 70 - 110 mm. The rainwater collector is intended solely for domestic use. This appliance is not intended for any other use or for uses beyond those detailed. Claims of any kind for damage resulting from unintended use will not be accepted. Items supplied / Parts description Figure A: 1 Crown drill bit 1 Flange for downpipe sizes 70-80 mm 1 Flange for downpipe sizes 90-110 mm 2 Flange gaskets 1 Rubber seal for the hole in the rainwater barrel (DN 19/32) 1 Clamping device 1 Rainwater collector with control valve and filter insert 1 Connection hose Figure B: with overflow protection with sommer-/winter operation Suitable for all vertical downpipes DN 70 - 110 mm 14 Buch_73211_LB2. 12 08:47 Figure C (Working materials needed): ■ Protective gloves ■ Protective goggles ■ Pencil ■ Spirit level ■ Drill ■ Detergent ■ Carpet knife/file GB Assembly Downpipe and rainwater barrel IMPORTANT ► The borehole in the downpipe is also the maximum filling height of the rainwater barrel. –º Be aware of unevenness in the terrain, so as to prevent subsequent overflows from the rainwater barrel. It is best to place the rainwater barrel at its final intended location and to then transfer the marking for the max. Ϭlling level onto the downpipe with a spirit level. Using a spirit level and a pencil, mark the hole positions onto the rainwater barrel and downpipe (see Figure D). Thereby, press the clamping device upwards slightly and then press it firmly into the downpipe (see Figure I). Turn the clamp nut clockwise until it is hand tight (see Figure I). Moisten the outer sides and the neck of the rubber tabs with detergent (see Figure J). Press the rubber tabs together and slide them through the opening of the clamping device into the downpipe. Ensure that the tongued and grooved connection between the clamping device and rainwater collector interlocks correctly (see Figure J). Insert from outside the supplied rubber seal DN 19/32 rainwater barrel. Moisten the end of the connecting hose 4. Firmly press the connection hose through the rubber seal DN 19/32. And the rainwater barrel with the connec- 16 Buch_73211_LB2. 12 08:47 Summer and winter operation To make the rainwater barrel frost-secure in winter, the feed should be shut off to rainwater barrel. [. . . ] And the rainwater barrel with the connec- 16 Buch_73211_LB2. 12 08:47 Summer and winter operation To make the rainwater barrel frost-secure in winter, the feed should be shut off to rainwater barrel. To do this, place the control valve at a right angle to the flow direction (see Figure L). GB Cleaning ■ Clean the outer surfaces of the rain water diverter with a damp cloth. [. . . ]