User manual TNB CSF800

[. . . ] Keep children away from electrical power tools!Risk of loss of life by electric shock from damaged mains lead or mains plug!Wear hearing protection, dust protection mask, protective glasses and protective gloves. Power carving tool CSF800 Q Introduction  Q Equipment  Please make sure you familiarise yourself fully with the way the device works before you use it for the first time and that you understand how to handle electrical power tools correctly. [. . . ] The use of these devices reduces the hazard presented by dust. Careful handling and use of electrical power tools 3. Personal safety a)  emain alert at all times, watch what R you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. B)  Wear personal protective equipment and always wear safety glasses. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. c)  void unintentional operation of the A device. Check that the electrical power tool is switched off before you connect it to the mains, pick it up or carry it. Accidents can happen if you carry the device with your finger on the ON / OFF switch or with the device switched on. D) emove any setting tools or spanners R before you switch the device on. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. There is a danger of injury from the very sharp attachment tools.  lways route the cable towards the back away A from the device. n cases of danger remove the plug from the I socket immediately. q Original  Accessories /  Additional Equipment 5. Service a) ave your device repaired at the serH vice centre or by qualified specialist personnel using original manufacturer parts only. This will ensure that your device remains safe to use.  se only the accessories and additional U equipment referred to in the instructions. The use of tools or other accessories which are not recommended in the instructions may represent a risk of injury. Q Operation  Q Turning  S  afety instructions for motor carving devices In order to avoid injury, fire and health hazards:  ecure the work piece. Use clamping S devices / a vice to hold the work piece. [. . . ] The appliance has been manufactured with care and meticulously examined before delivery. Please retain your receipt as proof of purchase. In the event of a warranty claim, please make contact by telephone with our Service Department. Only in this way can a post-free despatch for your goods be assured. [. . . ]