User manual TNB SECURITY LOCK CABLE MCAV3W

[. . . ] Regularly check the condition of the appliance, the power cables and the power plugs. V~ Voltage Food Slicer SECURITY LOCK CABLE MCAV3W Q Introduction  use of the appliance or are caused by incorrect operation of it. Q Items  Dear Customer, before using the electric Multi-Purpose Slicer for the first time please read carefully and thoroughly through these operating instructions and the safety advice, completely familiarising yourself with the appliance. You may find it useful to open out the page illustrating the slicer and describing both it and its operation. [. . . ] If it is not, - oosen both adjusting screws 16 for a lighter l movement rate or - ighten both adjusting screws 16 further for a t stiffer movement rate. Q Operation  Q Working  up the appliance S  pecific safety advice on the placing of the appliance 1.  Never set the electric Multi-Purpose Slicer up on a hot surface or near an open flame.  Ensure that the power cable 8 does not pass over hot or sharp-edged objects.  not allow the power cable 8 to become Do kinked or trapped and do not wrap it around the electric Multi-Purpose Slicer.  et the electric Multi-Purpose Slicer up on a S flat, non-slip surface close to a power socket.  nwind the required length of power cable 8 . U Insert the plug into the power socket.  lace the food carriage 10 on the supporting P table with guide slot 9 (see Fig. Now press the on the blade cover 6 high standing side down, so that the holding clamps (on the underside of the food carriage 10 ) engage. Ensure that these have correctly engaged, in that you check the mobility of the food carriage. continuous operation / max. 10 minutes (switch in position “I“):  et the switch for intermittent / continuous operS ation 3 to position “I“. The cutting blade 12 runs without it being necessary to hold the switch in this position. Halting continuous operation: Move the switch for intermittent / continuous operation 3 into the “0” position and wait until the cutting blade comes to a complete standstill. Intermittent operation (switch for intermittent / continuous operation in position “II“):  et the switch for intermittent / continuous S operation 3 to position “II“. The cutting blade will continue to run for as long as the switch for intermittent / continuous operation is held in this position. Halting intermittent operation: Release the switch for intermittent / continuous operation 3 and wait until the cutting blade comes to a complete standstill. Thickness – setting and cutting Set the required slice thickness using the control knob 14 (see Figure C). The settings on the scale do not correspond with the slice thickness in mm. For safety reasons the cuttingblade 12 is covered in setting “0“.  lace the food to be sliced on the food P carriage 10 . [. . . ] t is necessary to clean the electric Multi-PurI pose Slicer thoroughly at regular intervals as perishable food scraps could accumulate on the appliance or behind the cutting blade 12 .  lean all appliance parts not suitable for the C dishwasher with a lightly moistened cloth. Wipe off the appliance housing 5 , the cutting blade covering 6 , the support table with guide slots 9 and the food support plate 13 carefully. Do not use abrasive cleaning agents, sponges with rough surfaces or hard brushes. [. . . ]