User manual TOMTOM HP/GPS NAVIGATION - IPAQ HW6515

[. . . ] You will need to set up a Serial Port connection between the GPS receiver and your device. The GPS receiver will appear to your device as the "TomTom Wireless GPS" and its GPS signal will be output on its "GPS serial output". To ensure ease of use, create a Bluetooth bond between your device and the GPS receiver. After setting up the Bluetooth connection, you will need to modify the properties of the software on your PDA, Smartphone or laptop to use the GPS signal from the GPS receiver. [. . . ] After setting up the Bluetooth connection, you will need to modify the properties of the software on your PDA, Smartphone or laptop to use the GPS signal from the GPS receiver. Please refer to the documentation of your device, and of your software. Press and hold the power button for 3 seconds to perform reset. Your TomTom Wireless GPS receiver can be used when in your pocket or bag. When using it in a vehicle, make sure it is placed correctly for optimal GPS signal reception and stays in place. You can ensure that the GPS receiver gets a proper GPS signal by testing it in a stationary situation with your PDA or Smartphone. Note that many modern vehicles have a heat reflective shield embedded in the windshield preventing good reception when the GPS receiver is placed on the dashboard. If you have problems getting a GPS signal, try placing the TomTom Wireless GPS receiver behind a rear window of your car. You can change the adaptor of the AC plug to fit your local power outlet. 2 0000 -20 till +70 grader Celsius -10 till +60 grader Celsius Upp till 75 %, ingen kondens IP54 GPS is operated and controlled under the sole responsibility of the Government of the United States of America, which is responsible for its availability and accuracy. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · If you are using the equipment with a mains adapter, plug it into an outlet which is on a different circuit from that to which the receiver is connected. This equipment was tested for FCC compliance under conditions that included the use of shielded cables and connectors between it and the peripherals. It is important that you use shielded cable and connectors to reduce the possibility of causing radio and television interference. Shielded cables, suitable for the product range, can be obtained from an authorised dealer. If the user modifies the equipment or its peripherals in any way, and these modifications are not approved by TomTom, the FCC may withdraw the user's right to operate the equipment. For customers in the USA, the following booklet prepared by the Federal Communications Commission may be of help: "How to Identify and Resolve Radio-TV Interference Problems". This booklet is available from the US Government Printing Office, Washington, DC 20402. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. [. . . ] This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. This Class B digital apparatus complies with Canadian ICES-003. This equipment complies with the requirements for CE marking when used in a residential, commercial, vehicular or light industrial environment. [. . . ]