User manual TOMTOM ONE 130 RDS-TMC TRAFFIC RECEIVER USER GUIDE

[. . . ] EN RDS-TMC Receiver Guide RDSTMC Receiver Guide Introduction This guide explains how to set up the TomTom RDS-TMC Traffic Receiver, for receiving traffic information to help improve your journey times and travel planning. Getting started Before connecting the RDS-TMC Traffic Receiver for the first time, make sure your TomTom device is switched off. While your TomTom device is searching for a radio station, the following symbols are shown on the top of the Traffic bar: Your TomTom device is looking for a radio station. [. . . ] Position the TomTom device at the bottom left corner of the car windscreen. Press the transparent suction cup at the tip of the antenna firmly against the upper left corner of the car windscreen 5. Press the second transparent suction cup firmly against the bottom left corner of your windscreen. Place the egg shaped receiver with the black suction cup on the windscreen at any place convenient. Avoid putting too much tension on the cables. The Traffic bar is shown in the Driving View and your TomTom device searches for a radio station that carries RDS-TMC information. Setting the country If you are driving close to a country border, your TomTom device may tune to a radio station from a neigbouring country. If this happens you will only receive RDS-TMC traffic information for the neighbouring country. To avoid tuning to a radio station in another country, set the required country as follows: 1. Select the country that you want to receive traffic reports for. Your TomTom device searches for a radio station located in the country you have chosen. [. . . ] coated windscreen), surrounding environment (e. g. mountains, high buildings), RDS-TMC Radio station transmition signal. For more detailed information about specific Traffic incidents, tap the Traffic bar, then tap Show traffic info. [. . . ]